Tube cutter series, TK contains a safety lock feature and is used for cutting tubes of nylon, soft nylon, polyurethane, and other soft plastic tubes of 20mm or less.
Table of Contents Tighten the cap nut firmly by hand on the fitting. 1. Cut the tube perpendicularly to the tube axis to a little longer than required length. (Use tube cutter TK-1, TK-2 or TK-3.) 2. Push the tube until it comes to the end of the barb portion, or it may cause air leakage or release hose. 1. Tighten by hand, and give it an additional 1/4 rotation with wrench.
(Use tube cutter TK-1, TK-2 or TK-3.) qCut the tube perpendicularly to the tube axis with a little longer length than required length. (Use tube cutter TK-1, TK-2 or TK-3.)
Tighten the cap nut firmly by hand on the fitting. 1. Cut the tube perpendicularly to the tube axis to a little longer than required length. (Use tube cutter TK-1, TK-2 or TK-3.) 2. Push the tube until it comes to the end of the barb portion, or it may cause air leakage or release hose. 1. Tighten by hand, and give it an additional 1/4 rotation with wrench.
Installation and removal of tubing for One-touch fittings 1) Installation of tubing (1) Cut the tubing perpendicularly, being careful not to damage the outside surface. Use an SMC tube cutter TK-1, TK-2 or TK3.