Valve Mounting: 1 (Screw Mount Type), Filter: w/o Filter, Flow Rate/Operating Frequency: M (Flow 150 L/min; Power 4W; Max. Op Frequency 150Hz), Lead Wire: H (500 mm)

Valve Mounting: 1 (Screw Mount Type), Filter: w/o Filter, Flow Rate/Operating Frequency: G (Flow 100 L/min; Power 10W; Max. Op Frequency 300Hz), Lead Wire: G (300 mm)

Valve Mounting: 1 (Screw Mount Type), Filter: w/o Filter, Flow Rate/Operating Frequency: J (Flow 150 L/min; Power 80W; Max. Op Frequency 600Hz), Lead Wire: J (1000 mm)

Valve Mounting: 1 (Screw Mount Type), Filter: w/o Filter, Flow Rate/Operating Frequency: L (Flow 150 L/min; Power 10W; Max. Op Frequency 250Hz), Lead Wire: J (1000 mm)

Valve Mounting: 1 (Screw Mount Type), Filter: w/o Filter, Flow Rate/Operating Frequency: H (Flow 100 L/min; Power 4W; Max. Op Frequency 200Hz), Lead Wire: J (1000 mm)

Valve Mounting: 1 (Screw Mount Type), Filter: w/o Filter, Flow Rate/Operating Frequency: G (Flow 100 L/min; Power 10W; Max. Op Frequency 300Hz), Lead Wire: J (1000 mm)

CV/MVGQ

MXW MXP Grommet, L/M plug connector With light (lZ) MG MGP MGQ MGG MGC MGF CY1 MY1 3.5-5

AMD

Note 2) At oil mist density of 30 mg/m 3 ANR is blown out by compressor. Refer to Made to Order Specifications on page 14-20-55.

AMH

/m3 (ANR) (2) (At saturation of element oil, less than 0.01 mg/m 3 (ANR) 0.008 ppm) 2 years or when pressure drop reaches 0.1 MPa Element life Note 2) At oil mist density of 30 mg/m 3 ANR is blown out by compressor.

IDG

Specifications 0.01 m (95% filtered particle diameter) Filtration of outlet air Max. 0.1 mg/m3 (ANR) (0.08 ppm) Note) Outlet air oil mist concentration (Prior to oil saturated 0.01 mg/m3 (ANR) or less, (0.008 ppm or less)) Note) With inlet air oil mist concentration of 30 mg/m3 (ANR) (24 ppm) Applicable Model Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080

Hydraulic Cylinder 7MPa Nominal Pressure Series CHN

Load inertial energy E1 at the cushion seal contact point E1 = MV/2 = 50 x 0.3/2 = 2.25J Mg sin E = 3.7J 2. External force F applied in axial direction of the cylinder at the cushion seal contact point F = Mg sin = 50 x 9.8 x sin 30 = 245N 30 Mg 5.

70pvpump

Max. 1.0 mg/m3 Downstream oil mist concentration (ANR)( 0.8 ppm) (2) Note 1) With auto-drain is 0.15 MPa Note 2) When compressor discharge oil mist concentration is 30 mg/m3 (ANR) 2 years, or when pressure drop reaches 0.1 MPa Element life Specifications Filter regulator + Mist seperator Air combination Series AC2040/3040 Model Model AC2040 AC3040 AC4040

Possible to transfer a workpiece at low-speed.

Center of rotation and center of gravity of the load are concentric. mg F L L mg Friction force is applied. Rotation shaft is vertical (up and down). 2 Ta = = t2 Ts = F L Gravity is applied in rotating direction.

Clean Air Module

Pressure dew point: 3C Oil concentration: 0.1 mg/m3 With the above conditions, notation of the quality class is 1, 4, 2. 344 LLB Series Clean Air Module / Precautions 2 Be sure to read this before handling the products.

Exhaust Cleaner for Vacuum Pump AMV Series

(When greasy fumes are 1,000 mg/m3 at the IN side, it will be 5 mg/m3 or less at the OUT side.) Exhaust ducts from a vacuum pump is not necessary.

m (95% filtered particle size)Max. 0.1 mg/m3 (ANR) (Before saturated with oil: 0.01 mg/m3 (ANR) or less, approx. 0.008 ppm) (2)PolycarbonateStandard250.22

m (95% filtered particle size)Max. 0.1 mg/m3 (ANR) (Before saturated with oil: 0.01 mg/m3 (ANR) or less, approx. 0.008 ppm) (2)PolycarbonateStandard250.22

m (95% filtered particle size)Max. 0.1 mg/m3 (ANR) (Before saturated with oil: 0.01 mg/m3 (ANR) or less, approx. 0.008 ppm) (2)PolycarbonateStandard250.22

m (95% filtered particle size)Max. 0.1 mg/m3 (ANR) (Before saturated with oil: 0.01 mg/m3 (ANR) or less, approx. 0.008 ppm) (2)PolycarbonateStandard450.44

m (95% filtered particle size)Max. 0.1 mg/m3 (ANR) (Before saturated with oil: 0.01 mg/m3 (ANR) or less, approx. 0.008 ppm) (2)PolycarbonateStandard250.22