AS-FPQ/AS-FPG Adjustment of the position after mounting should be performed by turning Body A by hand. 4. Confirm that the lock nut is not loose. If the lock nut is loose, there may be dangerous changes in actuator speed 5. The number of opening and closing rotations of the needle valve should be adjusted within the range of the specifications.
: Vertical upward When a value has been displayed, it will be automatically reset when the pump is stopped.
(If used with Gateway unit, SI must be output only.)
Brackets for trunnion should be ordered separately. (mm) CV/MVG Bore size (mm) Part No.
Adjustment of the position after mounting should be performed by turning Body A by hand. 4. Confirm that the lock nut is not loose. If the lock nut is loose, there may be dangerous changes in actuator speed. 5. The number of opening and closing rotations of the needle valve should be adjusted within the range of the specifications.
Recommended speed controller Model Elbow type 10-AS2201F-01-06-X214 10-AS2201F-02-06-X214 10-AS2201F-02-06-X214 10-AS3201F-02-08-X214 10-AS3201F-02-08-X214 Model Straight type 10-AS2301F-01-06-X214 10-AS2301F-02-06-X214 10-AS2301F-02-06-X214 10-AS3301F-02-08-X214 10-AS3301F-02-08-X214 In-line type 10-AS2001F-06-X214 10-AS2001F-06-X214 10-AS2001F-06-X214 10-AS3001F-08-X214 10-AS3001F-08-X214
Part numbers written collectively can be complicated, thus specify by using a manifold specification form.
Be careful so that the cover of lead wire does not enter into the crimping part.
N.C. and N.O. common A differential pressure indicator or a differential pressure indication switch can be selected, and mounted on all filter models. Differential pressure indicator Operating pressure20 kPa Once a value is displayed, it will continue to be displayed until reset, even if the pump is stopped.
5 Caution Be sure to read before handling.
(Tightening torque of M5 screw should be 2 to 3 Nm.) 5. Modification of the detecting position should be made in the condition of 3.
(Tightening torque of M5 screw should be 2 to 3 Nm.) 5. Modification of the detecting position should be made in the condition of 3.
(Tightening torque of M5 screw should be 2 to 3 Nm.) 5. Modification of the detecting position should be made in the condition of 3.
(Tightening torque of M5 screw should be 2 to 3 Nm.) 5. Modification of the detecting position should be made in the condition of 3.
(Tightening torque of M5 screw should be 2 to 3 Nm.) 5. Modification of the detecting position should be made in the condition of 3.
(Tightening torque of M5 screw should be 2 to 3 Nm.) 5. Modification of the detecting position should be made in the condition of 3.
Non-locking push type must be pressed in the direction of the arrow. The locking type must be turned in the direction of the arrow.
Auto switches can also be mounted. It can be installed with auto switches to simplify the detection of the stroke position of the cylinder.
Note) A total of up to 3 SUP/EXH blocks can be mounted. Please contact SMC if 4 or more will be mounted.
Note) A total of up to 3 supply/exhaust blocks can be mounted. Contact P/A if 4 or more will be mounted.