<br>The D-MP□ series operation manual can be found here.

<br>Loosen the hexagon socket head cap screw that is stopping the stopper block from moving, and then adjust the angle as needed.

<br>Consider using an external stopper to perform intermediate stops. However, the stopper will pop out when operating from the intermediate position, so be sure to take measure to prevent this.

<br>Attached document

<br>Application example: For up/down driving through the combined use of an MSZ series rotary table and an MSZ series cylinder For details, refer to the video below. Video

<br>However, the amount of leakage will increase as the seal wears out.

<br>The MH□ series catalog can be found here.

<br>Features of the refreshed MHL2-Z series can be found here.

However, the mounting dimensions (screw pitch, screw size, etc.) are interchangeable.br/><br>

<br>Refer to the “Specific Product Precautions” in the MRHQ series catalog for details. The MRHQ series catalog can be found here.

<br>If a number other than “0” (the number that can be entered differs depending on the model) is entered, a pushing operation is performed.

<br>The operation manual can be found here.

<br>Check the switch setting (communication speed and station number and the address), the communication switch setting, and the controller (LEC) setting procedures in the “Initial Setting” section in the operation manual, which can be found here.

<br>When changing to a new operation in the middle of a positioning operation, give the new operation instruction after interrupting and stopping the operation once with a RESET signal.

<br>However, an alarm may be generated to alert you of the displacement of the moving part due to external force.

<br>Turn ON SETUP after checking SVRE ON output.

<br>The pressure welding of MIL connectors, etc., is possible.

<br>It turns ON when the servo is ON, and it turns OFF when the servo is OFF.

<br>Review the pressing start position.

<br>Check the EMG or M 24 signal.