MHL2

pinion mechanism Model/Stroke Max operating frequency (c.p.m) Opening/closing stroke (L2L1)(mm) Weight (g) Width at closing (mm) (L1) Width at opening (mm) (L2) Bore size (mm) Model Built-in dust proofing mechanism 60 20 40 60 30 60 80 40 80 100 50 100 120 70 120 160 100 160 200 56 78 96 68 110 130 82 142 162 100 182 200 150 198 242 188 246 286 76 118 156 98 170 210 122 222 262 150 282 320 220

MNB

Upper limit of allowable value Solenoid valve for locking mounted on the unlocking port Maximum value of stopping position dispersion from 100 measurements Spring Lock Holding Power (Maximum Static Load) 32 40 50 63 80 100 Bore size (mm) 552 {56} 882 {90} 1370 {140} 2160 {220} 3430 {350} 5390 {550} Holding power N {kgf} 2 Series MNB Bracket Part Numbers Rod Boot 32 40 50 63 MNB-L 80 100 Bore

Mechanically Jointed Rodless Cylinder Series MY2H/HT ø16, ø25, ø40

M2 M3 m1 m2 m3 16 25 40 16 25 40 7 6 7 15 13 13 MY2H 28 26 26 32 30 30 60 50 60 62 62 62 46 55 46 20 18 18 100 120 100 38 35 35 MY2HT 200 220 200 80 80 80 The above values are the maximum allowable values for moment and load. Refer to each graph regarding the maximum allowable moment and maximum allowable load for a particular piston speed.

Title not found

MVAny MVtype Valve will work here, set up Normally Open E SCS-112 1/8 Stroke Completion Sensor (SCS) SCS-250 SCS SCS-375 3/8 SCS SCS-500 SCS www.poweraire.com 1-800-526-7661 22 Section III: Circuits Two Hand Extend Two Hand Retract Use this circuit, where a pinch point exists on both the extension and retraction of the linear actuator.

Title not found

MVAny MVtype Valve will work here, set up Normally Open E SCS-112 1/8 Stroke Completion Sensor (SCS) SCS-250 SCS SCS-375 3/8 SCS SCS-500 SCS www.poweraire.com 1-800-526-7661 22 Section III: Circuits Two Hand Extend Two Hand Retract Use this circuit, where a pinch point exists on both the extension and retraction of the linear actuator.

Diaphragm Style Flow Switch Series IFW5 For details about certified products conforming to international standards, visit us at www.smcworld.com. 1

.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com 2 With neon light (110 VAC, Green) Flow range ZSP 3 With neon light (220 VAC, Red) Low flow setting possible (1 l/min) 10 1 to 10 l/min 4 With neon light (220 VAC, Green) 20 10 to 20 l/min Simple flow setting Without removing the cover, you can set

V

250 262.5 (L4) 135.5 135.5 148 160.5 173 185.5 198 198 210.5 223 235.5 248 260.5 260.5 273 Stations are counted from the D side Courtesy of Steven Engineering, Inc. !

Vacuum System Peripherals:

impedance ZU Approx. 6.5 k Voltage type Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com Approx. 2.7 k Preset input Right angle type cable connector Straight type cable connector ZL 1 to 5 VDC (Load impedance: 1 k or more) 4 to 20 mA (Sink type) (Load impedance: 250

3 Port Solenoid Valve Series VQ100 1

Plug-in, With light/surge voltage suppressor (Only for plug-in manifold) F Coil rated voltage 1 2 3 4 5 6 9 100 VAC (50/60 Hz) 200 VAC (50/60 Hz) 110 VAC (50/60 Hz) 220 VAC (50/60 Hz) 24 VDC 12 VDC Other L plug connector, With lead wire With light/surge voltage suppressor L L plug connector, Without connector With light/surge voltage suppressor LO For the special voltages, please consult

NCQ8

Mounting bolt C D Mounting Bolt Size for NCDQ8B056 to 250(With Auto Switch) (Inch) Model C D Bolt size Model C D Bolt size NCDQ8B056-025 037 050 062 075 087 100 125 150 175 200 250 300 350 400 NCDQ8B075-025 037 050 062 075 087 100 125 150 175 200 250 300 350 400 NCDQ8B106-025 037 050 062 075 087 100 125 150 175 200 250 300 350 400 NCDQ8B150-025 037 050 062 075 087 100 125 150 175 200 250

Air Cylinder

to 150 151 to 200 201 to 250 S ZZ S ZZ S ZZ S ZZ S ZZ 20 8 20 M4 x 0.7 87 120 112 145 137 170 25 8 20 M5 x 0.8 87 120 112 145 137 170 32 12 20 M6 x 1 89 122 114 147 139 172 164 197 40 13 21 M8 x 1.25 113 150 138 175 163 200 188 225 213 250 Symbol * When female thread is used, use a thin wrench when tightening the piston rod. * When female thread is used, use a washer etc. to prevent the

Air Slide Table

300 0 0 50 100 150 200 250 300 350 400 L3: Overhang Allowable range: 300 mm L3: Overhang Allowable range: 400 mm Allowable overhang L [mm] Allowable overhang L [mm] 167 Model Selection MXQ Series Determine the overhang.

Slider Type Ball Screw Drive/11-LEFS Series

Lx = 400 mm, Ly = 250 mm, Lz = 1500 mm 4.

0.4

.: 3.2, 1/8" 4, 5/32" 6, 1/4" n: Stations L: Dimensions n L 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 L1 55.5 66 76.5 87 97.5 108 118.5 129 139.5 150 160.5 171 181.5 192 202.5 L2 104.2 114.7 125.2 135.7 146.2 156.7 167.2 177.7 188.2 198.7 209.2 219.7 230.2 240.7 251.2 L3 125 137.5 150 162.5 175 187.5 187.5 200 212.5 225 237.5 250 250 262.5 275 L4 135.5 148 160.5 173 185.5 198 198 210.5 223 235.5

C95

, 320, 400, 500 40 1000 25, 50, 80, 100, 125, 160, 200, 250, 320, 400, 500 50 1000 25, 50, 80, 100, 125, 160, 200, 250, 320, 400, 500, 600 63 1000 25, 50, 80, 100, 125, 160, 200, 250, 320, 400, 500, 600 80 1000 25, 50, 80, 100, 125, 160, 200, 250, 320, 400, 500, 600 100 1000 25, 50, 80, 100, 125, 160, 200, 250, 320, 400, 500, 600 Intermediate strokes are available.

Industrial Filters

745 550 300 860 1650 2105 120 250 80 (3B) 100 (4B) 150 (6B) 65 (2 1/2B) 65 (2 1/2B) 630 920 37 750 24 317 795 600 300 880 1410 1865 120 250 80 (3B) 100 (4B) 150 (6B) 65 (2 1/2B) 65 (2 1/2B) 710 970 37 1000 24 394 795 600 300 880 1670 2125 120 250 80 (3B) 100 (4B) 150 (6B) 65 (2 1/2B) 65 (2 1/2B) 735 970 53 750 24 373 845 650 300 890 1420 1880 120 250 80 (3B) 100 (4B) 150 (6B) 65 (2 1/2B)

Process Valve

(mm) Symbol 1 2 3 Note 2) Port size Rc 100 VAC 50/60 Hz 200 VAC 50/60 Hz 110 VAC 50/60 Hz 220 VAC 50/60 Hz 24 VDC 12 VDC 240 VAC 50/60 Hz 1 2 3 Note 1) 4 Symbol Nil: Non-locking push type N.C. 1 MPa N.C. 0.5 MPa N.O. 1 MPa C.O. 1 MPa Note) 4 Note 2) A: Non-locking push type A (projecting) 1 6A 8A 10A 1 8 1 4 3 8 5 6 Note 2) 7 Valve size 1 to 4 7 Note 2) 11 15 11 10A 3 8 B: Slotted locking

VCS

Note 2) Vibration resistance Conditions when tested with one sweep of 10 to 250 Hz in the axial direction and at a right angle to the armature, in both energized and deenergized states No malfunction occurred when tested.

VCW

Note 4) Vibration resistance Conditions when tested with one sweep of 10 to 250 Hz in the axial direction and at a right angle to the armature, in both energized and deenergized states. No malfunction occurred when tested (value at the initial state).

VNB

.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com Valve type Port size Rated voltage Valve size 3 2 1 100 VAC 50/60 Hz Symbol Nil: Non-locking push type Orifice size (mm) Symbol Port size Rc 1 2 3 Note) 4 200 VAC 50/60 Hz 110 VAC 50/60 Hz 220 VAC 50/60 Hz Symbol N.C. 1 MPa N.C. 0.5 MPa N.O. C.O.