SMC Corporation of America
Elite Part Number Search
Search Results "NCDA1F250-2000-XB5"

-1.05 16.80 Psi 0 232.06 -15.2 243.7 (PD) 1000 5000 738 5200 ISE70 MPa (PD) PD [MPa] (PD)(ISE70 MPa) -62No.PS-OMV0003CN-G Pr = a (PD) + b (PD) = (Pr b) / a Pr PD a b [] a b MPa 0.00025 -0.25 kPa 0.25 -250 kgf/cm 2 0.002549 -2.549 ISE70 bar 0.0025 -2.5 psi 0.03626 -36.26 MPa 0.0004 -0.4 kPa 0.4 -400 kgf/cm 2 0.004079 -4.079 ISE71 bar 0.004 -4 psi 0.05802 -58.02 [] (ISE70 MPaPD=2000

) Pr = a (PD) + b = 0.00025 2000 0.25 = 0.25[MPa] (ISE70GMPaPr=0.75[MPa]) (PD) = (Pr b) / a = [0.75 (-0.25)]/0.00025 = 4000 -66No.PS-OMV0008CN-E IO-Link IODD IODD(I/O Device Description) IODD logo IODD IODD 1 ISE70G SMC-ISE70G-ymmdd-IODD1.1 2 ISE75G SMC-ISE75G-ymmdd-IODD1.1 3 ISE76G SMC-ISE76G-ymmdd-IODD1.1 4 ISE77G SMC-ISE77G-ymmdd-IODD1.1 5 ISE78G SMC-ISE78G-ymmdd-IODD1.1 "ymmddy

Serial interface unit EX500 is capable of controlling up to 64 solenoids, and is compatible with SV1000/2000/3000/4000, VQC1000/2000/4000 valves.  The EX500 makes it possible to connect up to 4 valve manifolds with up to 16 solenoids each. 

For VQC1000/2000 series valves, install valves with the same common specification as the common specification of your protocol.
③ Manifolds with kits other than the serial transmission kit (“S”), which includes options “F,” “L,” “M,” “P,” and “T,” do not have common polarity. Therefore, it is acceptable to mount either VQC1000/2000 positive common or negative common valves.

An ITV1000/2000/3000 series troubleshooting guide can be found in the “Operation Manuals” section of the SMC website.
The ITV1000/2000/3000 series troubleshooting guide can be found here.

The vertical scale shows the load on the cylinder and is in English tons (1 ton = 2000 lbs.) If the rod and and front end of the cylinder barrel are rigidly supported, then a smaller rod will be sufficient; use the column that is 1/2 the length of the actual piston rod.

MY1H40 Horizontal collision: P = 0.5 MPa MY1H25 Horizontal collision: P = 0.5 MPa 2000 1500 2000 1500 H unit Collision speed mm/s Collision speed mm/s H unit 1000 1000 L unit L unit 500 400 300 500 400 300 Air cushion Air cushion 200 200 Use this unit when operating with a load and speed exceeding the air cushion limit line, or when cushioning

(Value in the initial state) Vibration resistance: No malfunction occurred in one sweep test between 45 and 2000 Hz. Test was performed to axis and right angle directions of the main valve when pilot signal is ON and OFF.

(Value in the initial state) Vibration resistance: No malfunction occurred in one sweep test between 45 and 2000 Hz. Test was performed to axis and right angle directions of the main valve when pilot signal is ON and OFF .

(Value in the initial state) Vibration resistance: No malfunction occurred in one sweep test between 45 and 2000 Hz. Test was performed to axis and right angle directions of the main valve when pilot signal is ON and OFF.

(SCFM) FLOW AIR 3/32 *OIL FLOW (GPM) 4.0 200 1/16 3/32 3.0 150 1/16 3/64 100 2.0 3/64 1/32 1/32 50 1.0 0 3000 2000 1000 0 0 1000 2000 3000 0 (PSIG) PRESS . INLET PRESS . (PSI) *S.G. = .85 DROP OUTLET PRESS . = " O" PSI COAST PNEUMATICS 8055 E. CRYSTAL DRIVE, ANAHEIM, CA 92807 (714) 921-2255 WWW.COASTPNEUMATICS.COM SERIES 50 EW (5 WATTS AC & DC) MINIATURE HAZARDOUS LOCATION VALVES!

The vertical scale shows the load on the cylinder and is in English tons (1 ton = 2000 lbs.) If the rod and and front end of the cylinder barrel are rigidly supported, then a smaller rod will be sufficient; use the column that is 1/2 the length of the actual piston rod.

Eracket : HT-T| | | c,roc1 Port thre8d a | | Pressure gauge ffi ffi E fa*-l I i Oulpul prasure range . ffi ffi Input sisnar I #t*ilrirqf (No Curnl4-2ornA E 1/80) Cunenl0-20mA n li4(2000,,1000) Voltage 0-5V ry 3|/8(2000, 4o0o) Voftge 0-10V 1/2(4000) .71000.2000.4000 Gonstruction/Operation When the input signal increases, the piezo-electric tlapper O will dellect anq the nozzle will close O

Note 3) The minimum unit for 1ry205 is l PSl I'relerre# i.rirfilri:: i'fiprafi: How to Order Model Pressure 0 Current WDe 4 to 2OmA Cunent type 0 to 20mA 2 Voltaoe tvpe 0 to SVDC 3 Voltaoe tvoe 0 to 1oVDC connector type S : l Straioht tvDe 3m L Right angle type 3m N Without cable connector d Preset input Monitor output Option (bracket) Thread type Port size 2 114 (2OOO,3000 type) 3 3/8 (2000

Note 2) Do not use MGPL(ball bushing bearing) as a stopper. 1 5 10 20 30 40 50 Transportation speed: u (m/min) Bore Size 32 to 100/MGPM32 to 100 (Slide Bearing) MGPM32 to 100 (Slide Bearing) 2000 m u m u l @ 50mm l @ 50mm 100 1000 80 Transported object weight: m (kg) 63 500 400 50 300 40 200 *When requiring a bracket with a longer l dimension select a bore size large enough to accommodate

Series NCA1 medium duty tie rod cylinders are NFPA interchangeable, have a crimped piston rod assembly, are pre-lubricated and available in 11 mounting styles. Bore sizes range from 1.5 to 4 inches. The NCA1 expanded line of medium duty cylinders offer bore sizes ranging from 5 to 8 inches, and come standard with adjustable air cushion.5in. bore medium duty air cylinder, 11 NFPA mounting

This is a legacy product. Please contact us for the latest version.sales@ocaire.com, NFPA CYL/O.S. ROD/SWITCH, ACTUATOR, NCA1 TIE-ROD CYLINDER, PC, 2.5 INCH NCA1 OTHERS (COMBO), .00000 lb

This is a legacy product. Please contact us for the latest version.sales@ocaire.com, NFPA CYL/O.S. ROD/SWITCH, ACTUATOR, NCA1 TIE-ROD CYLINDER, PC, 2.5 INCH NCA1 OTHERS (COMBO), .00000 lb

This is a legacy product. Please contact us for the latest version.sales@ocaire.com, CYL, TIE ROD, OVSZ ROD, ACTUATOR, NCA1 TIE-ROD CYLINDER, PC, 2.5 INCH NCA1 OTHERS (COMBO), .00000 lb

This is a legacy product. Please contact us for the latest version.sales@ocaire.com, NFPA CYL/O.S. ROD/SWITCH, ACTUATOR, NCA1 TIE-ROD CYLINDER, PC, 2.5 INCH NCA1 OTHERS (COMBO), .00000 lb