EXxx-OMN0029CN No. 1 LED 2 3 4 (BUS OUT) 5 6 (PCI) 7 8 9 10 () 11 (BUS IN) 12 (2 ) (BUS OUTPCI) -18No.EX-OMN0029CN-D BUS IN BUS OUT 1 DRAIN 2 V+ 3 V4 CAN_H 5 CAN_L BUS OUT BUS OUT DeviceNetDeviceNet (BUS IN ) T SI IP67 DeviceNet -19No.EX-OMN0029CN-D (1) (2) (3) (4) (0.30.4 Nm) OFF OFF 0 -20No.EX-OMN0029CN-D Address/Data Rate DeviceNetData Rate Address (X10) DeviceNet Address (X1
(Default setting) 8 7 Configuration Mode Address X1 9 6 x10 x1 2 1 0 0 5 Mark C on the unit Mark B at cable end Mark A at cable end 4 Address 1 9 4 3 1 0 : : (1) 2 3 Input data + System diagnosis + Unit diagnosis (Up to 10 units) Input data + System diagnosis Input data only (Default setting) 8 7 9 6 6 Content 3 4 1 2 0 5 Content 5 0 (Default setting) 4 1 2 3 Node Address Data Rate 8 7 PGM
7 8 9 10 11 (BUS IN) 12 (2 ) (BUS OUTPCI) -16No.EX-OMN0027CN-D BUS IN BUS OUT 1 NC 2 RXD/TXD-N 3 NC 4 RXD/TXD-P 5 Shield T PROFIBUS DP BUS OUT SI IP67 PROFIBUS DP A [kbps] 9.6 19.2 45.45 93.75 187.5 500 1,500 3,000 6,000 12,000 [m] 1,200 1,000 400 200 100 -17No.EX-OMN0027CN-D (1) (2) (3) (4) (0.30.4Nm) OFF OFF 0, -18No.EX-OMN0027CN-D PROFIBUS DP (X10)PROFIBUS DP (X1
Red LERR LED is flashing 1 3 4 1 2 Content Err (Default setting) 5 2.5 Mbps 625 kbps Content 5 Mbps CC-Link version Node number 2.00 2.00 2.00 2.00 1.10 1.10 1.10 1.10 64 1 : 8 7 9 6 Number of occupied nodes x10 x1 0 5 4 4 Pin number 1 Address 2 3 5 3 1 4 2 3 2 1 1 4 3 2 1 (2) (3) Content 8 7 9 6 6 Number of occupied nodes SI unit output data size 4 byte (Default setting) 0 5 4 1 2 3 Signal
Extended cyclic occupied units RX/RY stations 1 15 1.10 x1 2 64/64 8/8 2 15 1.10 x1 4 128/128 16/16 3 15 2.00 x8 2 384/384 64/64 4 15 2.00 x8 4 896/896 128/128 5 31 2.00 x8 2 384/384 64/64 6 31 2.00 x8 4 896/896 128/128 7 63 2.00 x8 4 896/896 128/128 8 127 2.00 x8 4 896/896 128/128 * The last register of the bit area (16 bits) cannot be used as it is allocated for the system area.
ll9#x1'&l?3flrin c8-se of (6so)sr=13.6ks 1s) a=1366=6.6 catculation formuta tor cr (o<1) 3ff9i,3?
Table of applicable tubings (metric size) FEP, PFA, Modified PTFE, 2-layer soft fluoropolymer, Nylon, Soft nylon, Polyurethane, Hard polyurethane, Soft polyurethane, Polyolefin, Soft polyolefin, Wear Resistant Tubing , Antistatic soft nylon, Antistatic polyurethane 4x2.5, 4x3, 6x4, 8x6, 10x7.5 10x8, 12x9, 12x10, 16x13 1/8"x0.086", 5/32"x0.098", 1/4"x5/32" 5/16"x0.236", 3/8"x1/4", 1/2"x3/8
Model no. 1 3 5 A VZ X1 ( ) VZ3 A ( ) Manual override Entry is the same as standard products. Entry is the same as standard products.
Body Size: 4, Thread: Rc, Port Size: 06 (3/4), Handle/Bonnet Material: B (Aluminum), Options: BS (w/Bracket + Built-in Silencer, EXH Port), Semi-Standard: KR (K + R), Made to Order: X1 (Body: Red)
Body Size: 4, Thread: Rc, Port Size: 06 (3/4), Handle/Bonnet Material: B (Aluminum), Options: BS (w/Bracket + Built-in Silencer, EXH Port), Semi-Standard: K (Handle Color, Black), Made to Order: X1 (Body: Red)
Body Size: 4, Thread: Rc, Port Size: 06 (3/4), Handle/Bonnet Material: B (Aluminum), Options: S (Built-in Silencer, EXH Port), Semi-Standard: R (Flow Direction: Right to Left), Made to Order: X1 (Body: Red)
Regulator Unit Combination: [Other FRL Combination Devices] Other FRL Combination Device, Port Size: Rc3/4, Compressed Air Quality: General Dry Air, Maximum Operating Pressure(MPa): 1, Case Material: [Resin] Polycarbonate Case, Case Guard: No, Exhaust Structure: Relief type, Flow Direction: [Standard Flow (Left to Right)] Left to right, Drain Cock: [Not Provided] No, Pressure Gauge: No (No
Regulator Unit Combination: [Other FRL Combination Devices] Other FRL Combination Device, Port Size: Rc3/4, Compressed Air Quality: General Dry Air, Maximum Operating Pressure(MPa): 1, Case Material: [Resin] Polycarbonate Case, Case Guard: No, Exhaust Structure: Relief type, Flow Direction: [Reverse Flow (Right to Left)] Right to left, Drain Cock: [Not Provided] No, Pressure Gauge: -, Size
Body Size: 4, Thread: Rc, Port Size: 3/4, Handle/Bonnet Material: Aluminum, Options: w/Bracket + Built-in Silencer, EXH Port, Semi-Standard: K + R, Made to Order: Body: Red
Part Number Description: SEAL HOLDER Product Line: A Product Line Description: ACTUATOR Family Code: 405 Family Description: CS1 TIE-ROD CYLINDER Class Code: X1 Part Code: 2 Reference Code: J This is a custom made item that is NOT returnableClick here to report information errorImage shown may not match exact part number
GW unit setup The [Properties] screen will be displayed by double-clicking the [Interface] of the [Configuration table] window [Slot X1]. Tick the box for [Prioritized startup] in the [General] tab and press the [OK] button. The [Properties] screen will be displayed by double-clicking the Slot1 P1 or P2 (communication port using the FSU function) in the [HW Config] screen.
Configuration table][ ][Properties] (2)[Parameters] (3)[Value] (4)[OK]PLC (1) (1) (2) (2) (3) (4) (3) -62No.EX-OMQ0015CN FSU(First Start Up) EX600FSU FSUPLCFSU PLC (1)[HW Config]EX600 PLC PROFINET [Properties] (2)[Options] (3)[Connection][TP 100Mbps full duplex] (4)[Disable autonegotiation] (5)[OK] (1) (2) (3) (4) (5) -63No.EX-OMQ0015CN EX600 (1)[HW Config]EX600-SPN# (2)[Configuration table][Slot X1
Setting Node ID x100 x1 x10 1 0 1 0 2 0 2 0 Caution Outline Dimensions : : : : 238 2 3 8 After maintenance is complete, perform appropriate functional inspections. Stop operation if the equipment does not function properly.
Push Pull connector (24 Volt) 24V(US1) 0V(US1) 0 V (M OUT) 1 Power 24V(US2) 0V(US2) 0 V (M OUT) 2 DC / DC FE Safe 24V (ZONE OUT 1) 3 Output circuit OUT [0] 4 Push Pull connector (24 Volt) Safe 24V(US1) Input circuit 0V(US1) Power 24V(US2) OUT [7] 11 0V(US2) 24V (ZONE OUT 2) 12 FE Internal 13 OUT [8] Logic circuit Push Pull connector (SCRJ) ERTEC200 TX RX Bus 20 OUT [15] Port1 (x1
. = 4[V]x1% = 0.04[V]) The maximum measuring range or change in analogue output over the maximum measurement range. F.S. (Full span, Full scale) N Non-linear output Indicates non linear output. O Operating fluid temperature The fluid temperature range within which the product will meet all published specifications.