VFS Caution When using an exhaust cleaner, mount it downwards.
The test was performed in both an axial direction and a perpendicular direction to the lead screw.
Refer to p.0-44 to 0-46 for common precautions of auto switch.
Furthermore, it cannot be used as an emergency cutoff valve. Terminal deceleration and an intermediate speed change circuit can be produced easily. Universal porting could be used as a selector/divider valve. The simple system configuration permits sharp response. The large capacity system configuration without connection loss allows the use of smaller valves and piping.
In the ON condition an indicator LED will show, and any connected load will be powered. In the OFF condition, there will be no indicator LED and no power supplied to the load. An output showing such behavior is called switch output.
Do not use in an environment with temperature cycles.
Please place an order with cap type from the beginning.
If an alarm continues to be generated even after cleaning, the emitters may be worn out or damaged.
Furthermore, it cannot be used as an emergency cutoff valve.
(If no voltage contact is made, an operation failure signal will register.) IDF120D to 370B standard.
It converts air pressure to an equivalent hydraulic pressure, and this hydraulic pressure is used for operating an actuator, thus solving the problem that is associated with the compression characteristics of air.
It converts air pressure to an equivalent hydraulic pressure, and this hydraulic pressure is used for operating an actuator, thus solving the problem that is associated with the compression characteristics of air.
If there is an offset in the L2 direction, an eccentric load will be applied to the guide. In this case, pressing operations should not be performed.
System configuration Be sure to secure an air supply capacity of the minimum operating pressure (0.1 MPa) or more.
It converts air pressure to an equivalent hydraulic pressure, and this hydraulic pressure is used for operating an actuator, thus solving the problem that is associated with the compression characteristics of air.
A cabtire cable with an O.D. 6 to 12 mm is applicable. Tighten each part with an appropriate tightening torque shown below.
To operate a relay as a load, use the relay shown in the table below or the equivalent, in order to extend the life of the switch. qWhen handling the product, do not drop an object on it, gouge it, or apply an excessive impact on it. wDo not operate it in an area in which a large amount of magnetism is present.
Origin Home Switch Infotmation LX series actuators are available with an optional photo micro sensor as an origin home switch to detect when the actuator is fully retracted. The LCOC seies positioning drjver requires an input from the origin home switch or some other sensor when homing the actuator.
VVQ5000-25A1 5 Intermediate stop Drop prevention Can hold an intermediate cylinder position for an extended time. When combined with a double check spacer with built-in double check valve, it is unaffected by air leakage between the spool valves, making it possible to hold a cylinder at an intermediate stopping position for an extended time.
When the hydraulic pressure of an air-hydro unit must be raised. 7. When the pressure must be raised in an explosion-proof environment. 8.