Intrinsically Safe Valve If mounted in the wrong direction, the equipment to be connected may malfunction.
It may vary depending on connections.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
(After connection with a fitting, the drain may not flow due to a drop in pressure caused by the fitting.)
Overtightening may cause bending of the thread or air leakage due to deformation of the gasket. Insufficient screwing may cause loosening of the thread or air leakage.
This product communicates by radio waves, and the communication may stop instantaneously due to ambient environments and operating methods. SMC will not be responsible for any secondary failure which may cause an accident or damage to other devices or equipment.
The auto switch may be damaged if an unspecified screw is used.
In such cases, human injury may occur, e.g., by catching hands or feet in the machinery, or damage to the machinery itself may occur. Therefore, the machine should be designed to avoid such dangers. 2. Install a protective cover when there is a risk of human injury.
The equipment may be deformed or damaged, and if balance is lost, falling may cause injury. 2. Discharge drainage regularly. Accumulation of drainage in equipment, piping or other areas can cause malfunction of the equipment or unexpected trouble due to splash over into the downstream side, etc.
There may be the case it will vary substantially depending on an ambient environment. 16 Series CLK2 Auto Switch Mounting Bracket / Part No.
It may not be possible to connect them, or they may cause other trouble, such as air leakage or the tube pulling out after connection. 10 Air Suction Filter Series ZFC Specific Product Precautions Selection 1. Do not use in lines where a pressurized condition is maintained, as the body may be damaged. Warning Mounting 1.
However, once lubrication is applied it must be continued, as the original lubricant may be eliminated leading to malfunction. Contact SMC regarding Class 2 turbine oil (with additives), ISO VG32. 7.
Otherwise, unexpected malfunctions, such as knocking, may occur. 17. In the case of the belt driven actuator, vibration may occur during operation at speeds within the actuator specification, this could be caused by the operating conditions.
When an impact, such as water hammer etc., caused by the rapid pressure fluctuation is applied, the solenoid valve may be damaged. Give an attention to it.
Extended periods of continuous energization If a valve is continuously energized for long periods, heat generation of the coil may result in reduced performance and shorter service life. This may also have an adverse effect on the peripheral equipment in proximity.
Therefore, if an air compressor has a low air delivery, the pressure may not be sufficient. Auto Drain Caution The auto drain may not function properly, depending on the quality of compressed air. Check its operation once a day.
Therefore, if an air compressor has a low air delivery, the pressure may not be sufficient. Auto Drain Caution The auto drain may not function properly, depending on the quality of compressed air. Check its operation once a day.
If it is pulled off at an angle, the pilot valve may be damaged and/or the protective Oring may be scratched. Installation Place the cover straight over the pilot assembly so that the pilot valve is not touched, and push it until the cover hook locks without twisting the protective O-ring. (When pushed in, the hook opens and locks automatically.)
At higher temperatures the outside diameter rate of change may exceed 10% within the minimum bending radius.
At higher temperatures the outside diameter rate of change may exceed 10% within the minimum bending radius.