Title not found Then multiply the number by the actual length of pipe, in feet, then divide by 1000. This result is the pressure loss in PSI.
500 500 1000 1500 Flow rate L/min Flow rate L/min (ANR) Flow rate L/min (ANR) SRH4100-03 SRH4110-03 SRH4100-03 0.5 0.20 0.20 0.4 Outlet pressure MPa Outlet pressure MPa Outlet pressure MPa 0.15 0.15 0.3 0.10 0.10 0.2 0.05 0.05 0.1 1000 500 10 5 0 15 20 25 500 1000 1500 0 0 Flow rate L/min (ANR) Flow rate L/min (ANR) Flow rate L/min 858 Clean Regulator SRH Series Pressure Characteristics
consumption (W) Max. operating frequency (Hz) A 80 1200 B 40 1000 C 10 550 D 4 350 E Note) Two mounting screws (M3 x 0.5) and a gasket are included.
Then multiply the number by the actual length of pipe, in feet, then divide by 1000. This result is the pressure loss in PSI.
1900 1000 1900 70 1600 Set pressure range (MPa) 0.2 to 2.0 0.2 to 1.0 0.2 to 1.0 0.2 to 1.6 0.2 to 2.0 AR425 to 935 Supply pressure range (MPa) 0.1 to 1.0 Proof pressure (MPa) 2.4 3 3 1.5 ARX Port size (Rc) (IN/OUT/EXH: 3 locations) 3/8 1/2 3/8 1/2 1/4 1/4 AMR Pressure gauge port size (Rc) (IN/OUT: 2 locations) 1/8 ARM Tank connection port (with plug) Note 5) 1/4 3/8 1/2 3/8 1/2 1/4 Ambient
Bore size System Average speed [mm/s] MB, CA2 series Pressure 0.5 MPa, Load ratio 50%, Stroke 500 mm 40 50 63 80 100 1000 900 800 700 600 500 400 300 200 100 0 Vertically upward Horizontal A 1000 900 800 700 600 500 400 300 200 100 0 B 1000 900 800 700 600 500 400 300 200 100 0 C Bore size System Average speed [mm/s] CS1/CS2 series Pressure 0.5 MPa, Load ratio 50%, Stroke 300 mm 125 140 160
, 150, 200, 250, 300, 350, 400, 450, 500, 600, 700, 800 25 3000 32 3000 40 100, 150, 200, 250, 300, 350, 400, 450, 500, 600, 700, 800, 900, 1000 50 5000 63 Note 1) Long stroke type (XB11) applies to the strokes exceeding 2000 mm.
Cylinder speed-1000 mm/sec. Sequencer response time-0.1 sec. Detecting point despersion-Within 100mm (=1000 mm/sec. X 0.1sec.) Take PLC response time into consideration when using.
Note 4) Grommet type (G) is also available for C-kit, single type of VQ0/1000/2000.
PDisconnectionPress the lever against the connector housing and pull it outward from the solenoid : 300 600 1000 1500 2000 2500 3000 5000 For DC SYJ312-5LO-M3 SY100-30-4A-20 6 10 15 20 25 30 50 How to Order To order a valve with lead wire length of other than 300mm, indicate part numbers. of the valve without connector and the required connector assembly separately.
X Tank capacity 1000 Relief time that is read t = 2000 1000 = X 23 = 46 The result is 46S. From the above, the relief time is 263=23S 5.1-5 VEX1 Construction/Operation Principles/Component Parts [1] When A port pressure is high. [3] When A port pressure is low.
500 3000 0 0 2500 2000 1500 1000 500 3000 Flow rate l/min (ANR) Flow rate l/min (ANR) ARBQ5000-00-P (PA) ARBQ5000-00-P (PB) 0.7 0.7 0.6 0.6 Downstream pressure MPa Downstream pressure MPa 0.5 0.5 0.4 0.4 0.3 0.3 0.2 0.2 0.1 0.1 0 0 2500 2000 1500 1000 500 3000 0 0 2500 2000 1500 1000 500 3000 Flow rate l/min (ANR) Flow rate l/min (ANR) Note: 1MPa = 145psi 1l/min = 0.035SCFM Pressure Characteristics
I , ~ R. t:l' t y X BN N X Y 1 S + Stroke H LS + Stroke ZZ + Stroke Long Stroke Bore size Stroke ) (mm) range (mm) RT RV 40 501-800 50 601 1000 1001 1200 30 76 , 63 601-1000 1001-1200 40 92 80 751-1000 1001 1400 45 112 100 7511000 . . .
st: , 1001 to 1500 st: JIS Symbol Standard Stroke Maximum manufacturable stroke (mm) Minimum stroke (1) Bore size (mm) Standard stroke (2) (Recommended) (mm) 20 150 Up to 700 25 150 Up to 700 1500 32 150 Up to 1000 40 200 Up to 1000 Note 1) The cylinder performance may not as expected when stroke is longer than recommended stroke even they are available.
AS3201F, AS3211F AS3301F, AS3311F AS4201F, AS4211F AS4301F, AS4311F Inlet pressure: 0.5 MPa Inlet pressure: 0.5 MPa 12, 13, 16 10, 11, 12 1500 1000 10, 11 Flow rate L/min (ANR) Flow rate L/min (ANR) 08, 09 06, 07 1000 500 500 0 0 5 0 10 5 0 10 Number of needle rotations Number of needle rotations Note) The numbers above the flow rate characteristic curves in the charts show the applicable
Auto Switches Common Specifications Type Solid state auto switch Reed auto switch Leakage current 3-wire: 100 A or less, 2-wire: 0.8 mA or less None Operating time 1ms or less3) 1.2 ms Impact resistance 1000 m/s2 4) 300 m/s2 Insulation resistance 50 M or more (500 VDC measured via megohmmeter) (Between lead wire and case) 1500 VAC for 1 minute1) 1000 VAC for 1 minute (Between lead wire and
PTFE (TF) option available for the AP 500, AP, AZ & AK 1000 & 1100 and AZ & AK 1300. The primary application for this material is for pressure regulators inside process tools. [Vespel] Trademark of DuPont Plastic with excellent heat resistance (polyimide resin). This material has excellent heat and wear resistance.
st: , 1001 to 1500 st: JIS Symbol Standard Stroke Maximum manufacturable stroke (mm) Minimum stroke (1) Bore size (mm) Standard stroke (2) (Recommended) (mm) 20 150 Up to 700 25 150 Up to 700 1500 32 150 Up to 1000 40 200 Up to 1000 Note 1) The cylinder performance may not as expected when stroke is longer than recommended stroke even they are available.
Auto Switches Common Specifications Solid state auto switch Type Reed auto switch 3-wire: 100 A or less, 2-wire: 0.8 mA or less Leakage current None Operating time 1 ms or less 1.2 ms Impact resistance 1000 m/s2 300 m/s2 50 M or more at 500 VDC Mega (Between lead wire and case) Insulation resistance 1500 VAC for 1 minute (Between lead wire and case) 1000 VAC for 1 minute (Between lead wire
AXT661ALead wire length (mm) 6 43 Blanking plate with connector Connector Connector lead wire length (mm) 43 44 4-wire 2-wire Lead wire color: Black Lead wire color: Red Nil 300 600 1000 2000 3000 Nil 300 20 25 30 2000 6 10 20 30 Nil Without connector With connector/2-wire With connector/4-wire 1 2 6 10 15 600 2500 1000 3000 Lead wire color: White 24AWG 1500 Cover O.D. 1.5 Blanking plate