IDU/IDF (If no voltage contact is made, an operation failure signal will register.) IDF120D to 370B standard.
It converts air pressure to an equivalent hydraulic pressure, and this hydraulic pressure is used for operating an actuator, thus solving the problem that is associated with the compression characteristics of air.
It converts air pressure to an equivalent hydraulic pressure, and this hydraulic pressure is used for operating an actuator, thus solving the problem that is associated with the compression characteristics of air.
If there is an offset in the L2 direction, an eccentric load will be applied to the guide. In this case, pressing operations should not be performed.
System configuration Be sure to secure an air supply capacity of the minimum operating pressure (0.1 MPa) or more.
It converts air pressure to an equivalent hydraulic pressure, and this hydraulic pressure is used for operating an actuator, thus solving the problem that is associated with the compression characteristics of air.
A cabtire cable with an O.D. 6 to 12 mm is applicable. Tighten each part with an appropriate tightening torque shown below.
To operate a relay as a load, use the relay shown in the table below or the equivalent, in order to extend the life of the switch. qWhen handling the product, do not drop an object on it, gouge it, or apply an excessive impact on it. wDo not operate it in an area in which a large amount of magnetism is present.
Origin Home Switch Infotmation LX series actuators are available with an optional photo micro sensor as an origin home switch to detect when the actuator is fully retracted. The LCOC seies positioning drjver requires an input from the origin home switch or some other sensor when homing the actuator.
VVQ5000-25A1 5 Intermediate stop Drop prevention Can hold an intermediate cylinder position for an extended time. When combined with a double check spacer with built-in double check valve, it is unaffected by air leakage between the spool valves, making it possible to hold a cylinder at an intermediate stopping position for an extended time.
When the hydraulic pressure of an air-hydro unit must be raised. 7. When the pressure must be raised in an explosion-proof environment. 8.
Install an after-cooler, air dryer or water separator, etc. Air that contains excessive drainage can cause malfunction of valves and other pneumatic equipment. To prevent this, install an after-cooler, air dryer or water separator, etc. 3. Use the product within the range of specifications for fluid and ambient temperature.
When cleaning valve number is an even number, use the blanking plug for 2 port valve. Note) Maximum mountable valve number: 40 pcs.
DNote) When the digital filter setting (ON/OFF) is changed, an error count will occur. Reset the count value.
Wa = 1 x 1.2 = 1.2 Allowable load weight coefficient b: Graph (1) = 1 Max. allowable load weight Wmax: Table (2) Wmax = 1.2 1 = 0.2 / 1.2 = 0.17 1 = W/Wa Find the load factor of the load weight 1. 3-2 Load Factor of the Static Moment M = W x 9.8 (Ln + An)/1000 Moment center position distance compensation amount An: Table (3) Find the static moment M (Nm). Examine Mr.
An application which could have negative effects on people, property, or animals requiring special safety analysis. 4. Use in an interlock circuit, which requires the provision of double interlock for possible failure by using a mechanical protective function, and periodical checks to confirm proper operation. 1.
Install an air filter. Install an air filter upstream near the valve. Select an air filter with a filtration size of 5 m or smaller. 2. Take measures to ensure air quality, such as by installing an aftercooler, air dryer, or water separator. Compressed air that contains a large amount of drainage can cause a malfunction of pneumatic equipment such as valves.
As a guide, an acceptable tightening level is reached by tightening the screw an additional 90 degrees (1/4 turn) from the point at which the screw is snug. (Refer to Figure 3.)