SMC Wireless System EtherNet/IP ® compatible Adaptation for the connector may vary on account of the conductor construction of the electric wire. -116No.EX-OMU0028-D Revision history A: Contents are added. [May 2018] B: Contents revised in several places. [January 2019] C: Contents are added. [May 2019] D: Contents are added.
Spatter may cause fire. Consult with SMC if using in such an environment. (8) Do not use in an environment where water splashes onto the product frequently. Rust may be generated easily. (9) Do not use the product in a place or environment where foreign matter may get stuck to or get inside the product. This can cause air leakage or disconnection of the tubing. Maintenance !
If the bending radius is less than the minimum value, fittings may damage, or tubing may crack or be crushed.
Data may be erased.
If the operation is restarted within five minutes, the protection circuit may activate and the operation may not start properly. 2. Operation and suspension frequency should not exceed 10 times per day. Frequently switching between operation and suspension may result in the malfunction of the refrigeration circuit.
Therefore, the load may not be able to fully operate. The detectable piston speed V is expressed by the equation below.
This product communicates by radio waves, and the communication may stop instantaneously due to ambient environments and operating methods. SMC will not be responsible for any secondary failure which may cause an accident or damage to other devices or equipment.
Operating and Storage Environments In such cases, human injury may occur; e. g., by catching hands or feet in the machinery, or damage to the machinery itself may occur. Warning 2. Provide a cover to minimize the risk of 1. Envionments to avoid human injury.
If the tightening torque is exceeded the mounting screws and brackets may damaged. If the tightening torque is insufficient, the product may be displaced and the mounting screws may come loose. (Refer to page 15 "Mounting and Installation".) Ensure that the FG terminal is connected to ground when using a commercially available switch-mode power supply.
Melting may be caused by such chemicals splashed on the sensor, resulting in possible decline of performance. 1. Do not operate beyond the rated voltage range. If applying voltage over the rated voltage range, equipment may be damaged. 2. Avoid incorrect wiring such as polarity of power supply. Otherwise, equipment may be damaged. 3. Do not short circuit the load.
Do not use tools on the pressure regulator knob as this may cause damage.
Note) If not operating within the specified range of pressure and temperature, trouble may result.
It may not be possible to connect them, or they may cause other trouble, such as air leakage or the tubing coming out after connection. Built-in Back Pressure Check Valve Type Caution 1. Valves with built-in back pressure check valve are to protect the back pressure inside a valve.
{Tightening torque: 0.8 to 1.2 Nm} If the exhaust of the double check block is restricted too much, the cylinder may not operate properly and may not stop intermediately.
"WARNING" denotes that there is a hazard which may cause serious personal injury or death during operation. "CAUTION" denotes that there is a hazard which may cause minor personal injury during operation. "CAUTION" without an exclamation point denotes that there is a hazard which may cause damage to or the failure of the system, facility, or devices.
It may vary substantially depending on an ambient environment.
Excess torque may break the stopper.
If a pressure gauge, etc. is screwed in, the port may be damaged.
Furthermore, abnormal temperature rise caused by adiabatic compression may result in the tube bursting. Note 3) Do not use this product in a manner in which the tube is not fixed. Observe the lesser value of the maximum operating pressure between the tubing and fitting. A material change over a long duration or due to high-temperature may cause leakage.
If it is pulled off at an angle, the pilot valve may be damaged or the protective Oring may be scratched.