HEC_W-E Once the fluid is contaminated, it may degrade the performance or shorten the life time.
This may cause a broken lead wire or damage to the auto switch internal elements. (4) Use only the screws installed in the auto switch body for mounting the auto switch. If other screws are used, the auto switch may be damaged. (5) Mount the auto switch at the centre of its operating range.
The accuracy may decrease without a rotation stopper. With some cylinders, the magnet may rotate even when the piston rod does not rotate. The magnet inside some cylinders with guide may rotate.
If handled improperly, human injury and/or malfunction or damage of machinery and equipment may occur. 2. Do not use in an environment where flammable gas or explosive gas exists. Usage may cause a fire or explosion. The products do not have an explosion proof construction. 2.
Failing to comply may cause an injury or accident, or damage to the actuator and the user's system. 31 - 4.2.
The fittings may be damaged if they are used in the above manner. (2) The tubing bending radius in the vicinity of the fitting should be at least the minimum bending radius of the tubing. If the bending radius is less than the minimum value, fittings may be damaged, or tubing may crack or be crushed.
If the fitting is tightened with excessive torque, it may break.
Connection thread Proper tightening size torque Nm M3 0.40.5 M5,10-32UNF 11.5 Note) Excessive tightening may damage the thread portion or deform the gasket and cause air leakage. If the screw is too shallowly screwed in, it may come loose or air may leak.
This may cause secondary damage to the output circuit, external peripheral device, or valve, and may also cause a fire.
The product may be broken and cause malfunction. 7. Installation of a high-voltage line and the power line in the same wiring route may cause malfunction due to noise. Install them separately. 8. Be sure there is no incorrect wiring before operation. Incorrect wiring may cause the product to break or malfunction. 9. Flush pneumatic piping before installing.
It may not be applicable when a seal material different from the current one has been chosen.
Under certain conditions, the exhaust of the vacuum ejector may generate intermittent noises, and vacuum pressure may be uneven.
If the tightening torque is exceeded the mounting screws and brackets may damaged. If the tightening torque is insufficient, the product may be displaced and the mounting screws may come loose. (Refer to page 14 Mounting and Installation.) Ensure that the FG terminal is connected to ground when using a commercially available switch-mode power supply.
If the countermeasures above are not effective, there may be a problem with the valve. In that case, stop using the valve immediately.
In such cases, injury may occur, such as hands or feet getting caught in the machinery, or damage to the machinery itself may occur. Design the machinery using equipment to prevent sudden action. -4- ActuatorsPrecautions Be sure to read this before handling.
When supply pressure is below 0.3 MPa brake may not be released, when it is over 0.5 MPa brake life may be shortened. If line pressure is used directly as supply pressure, any fluctuation in pressure will appear in the form of changes in cylinder characteristics.
Scratches or dents on the surface of the rod may cause unusual wear on the inner surface of the brake pad or decrease its holding force.
Otherwise, it may cause insufficient set pressure. 9-2.
Otherwise, it may cause insufficient set pressure. 9-2.
If an excessive force is applied on the connector in the LOCK position, the connector block may be damaged.