Compressed Air Preparation Filter Insufficient tightening torque may result in loosening or sealing failure. Excessive tightening torque may damage the thread, etc.
The following procedures are an example of how a test may be performed. It is intended as an overview and not as an all inclusive description. 1) Rotate the adjustment wheel counterclockwise (DECR) completely to relieve spring force.
Air leakage may be happened, depending on the position in which a rod seal is fitted.
The product may be damaged if a voltage over this value is applied. (The withstand voltage is not the supply voltage used to power the product.)
Although error is displayed when the load at the output part has a short circuit, generated over current may lead to the damage of the product. Do not press the setting buttons with a sharp pointed object. It may damage the setting buttons. Warm up the product for 10 to 15 minutes first.
Forcible force may apply to frame or case due to concave and convex or deformed mounting face and large level gap, and it may cause breakage or operation failure. Also, dropping or strong impact may cause operation failure or accident. 3. Do not install with strong electromagnetic source. Installation with strong electromagnetic source may cause malfunction.
Fluids that solidify or being cured may block the leak detection so port and leak may not be detected. 2. If applying high voltage to the fluid, it must be earthed by using the bolt to mount the base. Do not use sealing tape when piping, as it may insulate. e If the union nut is loose, tighten it by hand temporarily.
This may cause human injury and/or an accident. Holding the parts other than the specified part to screw the product may cause damage to the product.
The product may be damaged if a voltage over this value is applied. (The withstand voltage is not the supply voltage used to power the product.)
Incorrect handling of the product may cause breakage or operation failure of the equipment or device. (3) Perform periodical check to find cracks, flaws or other deterioration on resin bowl. If any of these appear, replace with a new or metal bowl. Otherwise, breakage may occur.
Do 7 Data Length Sets data length for communication. 7Bits, 8Bits 8 prolonged period may damage the pump.
When a switch is tightened beyond the specified tightening torque, the switch may be damaged. On the other hand, tightening below the specified tightening torque may cause the installation screws to come loose during operation.
If vibration is applied, malfunction or setting errors may result. 14-4-50 33 F.R.L.
When a switch is tightened beyond the specified tightening torque, the switch may be damaged. On the other hand, tightening below the specified tightening torque may cause the installation screws to come loose during operation.
(Hum sound may generate because of no shading coil for DC.
(a) Station numbers may be set within the range 1 to 64. (b) One driver occupies 1 or 2 stations.
(a) Station numbers may be set within the range 1 to 64. (b) One driver occupies 1 or 2 stations.
The pressure may not reach 0.1MPa when the air compressor discharge flow rate is small. Dehumidified drain may flow into the secondary piping if there is sudden change of pressure or flow speed. Do not use the product where those condition is present.
Incorrect handling of the product may cause breakage or operation failure of the equipment or device. (3) Perform periodical check to find cracks, flaws or other deterioration on resin bowl. If any of these appear, replace with a new or metal bowl. Otherwise, breakage may occur.
Insufficient tightening torque may cause loosening or sealing failure and excess tightening torque may cause damage to threads. Tightening without holding female threaded side, excess force is applied to the bracket directly, and may cause breakage. Recommended tightening torque Unit: N-m Thread size 1/8 1/4 3/8 1/2 Torque 7 to 9 12 to 14 22 to 24 28 to 30 4.