Body Size: 40, Thread: Rc, Port Size: 06 (3/4), Handle/Bonnet Material: B (Aluminum), Options: None, Semi-Standard: R (Flow Direction: Right to Left), Made to Order: X1 (Body: Red)
Body Size: 5, Thread: Rc, Port Size: 06 (3/4), Handle/Bonnet Material: B (Aluminum), Options: S (Built-in Silencer, EXH Port), Semi-Standard: None, Made to Order: X1 (Body: Red)
Body Size: 5, Thread: Rc, Port Size: 06 (3/4), Handle/Bonnet Material: B (Aluminum), Options: None, Semi-Standard: R (Flow Direction: Right to Left), Made to Order: X1 (Body: Red)
Regulator Unit Combination: [Other FRL Combination Devices] Other FRL Combination Device, Port Size: Rc3/4, Compressed Air Quality: General Dry Air, Maximum Operating Pressure(MPa): 1, Case Material: [Resin] Polycarbonate Case, Case Guard: No, Exhaust Structure: Relief type, Flow Direction: [Standard Flow (Left to Right)] Left to right, Drain Cock: [Not Provided] No, Pressure Gauge: No (No
Body Size: 5, Thread: Rc, Port Size: 3/4, Handle/Bonnet Material: Aluminum, Options: None, Semi-Standard: Flow Direction: Right to Left, Made to Order: Body: Red
EX500-GEN2_eng Safety cannot be assured in the case of unexpected malfunction. x100 x1 x10 6 Seal cap (for M12 connector socket): 5 pcs.
EX245-DX1 2Byte Table 11-3 X0 X1 X2 X3 X4 X5 X6 X7 2 Bit 1 Bit 3 Bit 5 Bit 7 Bit 9 Bit 11 Bit 13 Bit 15 4 Bit 0 Bit 2 Bit 4 Bit 6 Bit 8 Bit 10 Bit 12 Bit 14 72 No.EX##-OMY0006CN 11.5. LED EX245-DX1 LED 0 15 OFF ON Fig. 11-2 EX245-DX1 LED 73 No.EX##-OMY0006CN 11.6.
For actuators with a stroke less than 1000mm, set parameter PE02 (Feed function selection) to 0 and the "Feed length multiplication (STM) (Multiplier)" value to x1. For actuators with a stroke more than 1000mm, set parameter PE02 (Feed function selection) to 0001 and the "Feed length multiplication (STM) (Multiplier)" value to x10.
P2, L5 X1 S/S . P3, L10 1 2 1 2 1/2 B Thd D A Thd C Hole Dia. Stainless Steel Threaded Parts Page & Part No. Line No. Page & Part No. Line No. D Line No.
Standard part number X1 Clean room specifications Specifications Non-grease specifications Cleanliness Bleed port Class 10 With M5 fitting (applicable tube O.D. 6) Manifold Specifications (except type IR2120 and series IR3000) 6 IR1000/2000: M5 fitting (applicable tube O.D. 6) IR3000: Rc(PT) 1/2 female thread EXH port Grease Teflon grease 2 to 8 station manifold type regulators.
(650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com Fluid Air VR Operating pressure 0.1 to 1.0 MPa Ambient temperature and operating fluid temperature 5 to 60C (No freezing) VH Handle switching angle 90 Required switching force 73.6 N (at 1.0 MPa) Paint color (Standard) Handle: Black, Body: Platinum silver Note) VHS Note) Handle: Silver, Body: Red (Made to order -X1
No. 1 LED 2 3 4 (BUS OUT) 5 6 (PCI) 7 8 9 10 () 11 (BUS IN) 12 (2 ) (BUS OUTPCI) -18No.EX-OMN0029CN-D BUS IN BUS OUT 1 DRAIN 2 V+ 3 V4 CAN_H 5 CAN_L BUS OUT BUS OUT DeviceNetDeviceNet (BUS IN ) T SI IP67 DeviceNet -19No.EX-OMN0029CN-D (1) (2) (3) (4) (0.30.4 Nm) OFF OFF 0 -20No.EX-OMN0029CN-D Address/Data Rate DeviceNetData Rate Address (X10) DeviceNet Address (X1
(Default setting) 8 7 Configuration Mode Address X1 9 6 x10 x1 2 1 0 0 5 Mark C on the unit Mark B at cable end Mark A at cable end 4 Address 1 9 4 3 1 0 : : (1) 2 3 Input data + System diagnosis + Unit diagnosis (Up to 10 units) Input data + System diagnosis Input data only (Default setting) 8 7 9 6 6 Content 3 4 1 2 0 5 Content 5 0 (Default setting) 4 1 2 3 Node Address Data Rate 8 7 PGM
7 8 9 10 11 (BUS IN) 12 (2 ) (BUS OUTPCI) -16No.EX-OMN0027CN-D BUS IN BUS OUT 1 NC 2 RXD/TXD-N 3 NC 4 RXD/TXD-P 5 Shield T PROFIBUS DP BUS OUT SI IP67 PROFIBUS DP A [kbps] 9.6 19.2 45.45 93.75 187.5 500 1,500 3,000 6,000 12,000 [m] 1,200 1,000 400 200 100 -17No.EX-OMN0027CN-D (1) (2) (3) (4) (0.30.4Nm) OFF OFF 0, -18No.EX-OMN0027CN-D PROFIBUS DP (X10)PROFIBUS DP (X1
Red LERR LED is flashing 1 3 4 1 2 Content Err (Default setting) 5 2.5 Mbps 625 kbps Content 5 Mbps CC-Link version Node number 2.00 2.00 2.00 2.00 1.10 1.10 1.10 1.10 64 1 : 8 7 9 6 Number of occupied nodes x10 x1 0 5 4 4 Pin number 1 Address 2 3 5 3 1 4 2 3 2 1 1 4 3 2 1 (2) (3) Content 8 7 9 6 6 Number of occupied nodes SI unit output data size 4 byte (Default setting) 0 5 4 1 2 3 Signal
Extended cyclic occupied units RX/RY stations 1 15 1.10 x1 2 64/64 8/8 2 15 1.10 x1 4 128/128 16/16 3 15 2.00 x8 2 384/384 64/64 4 15 2.00 x8 4 896/896 128/128 5 31 2.00 x8 2 384/384 64/64 6 31 2.00 x8 4 896/896 128/128 7 63 2.00 x8 4 896/896 128/128 8 127 2.00 x8 4 896/896 128/128 * The last register of the bit area (16 bits) cannot be used as it is allocated for the system area.
Type of seal Special Options R Rubber S Metal Standard X1 External Pilot Supply Size 6 Size 1 8 Size 2 10 Size 3 Pilot Exhaust Options Pilot Exh. through footprint V1 External Individual Pilot Exhaust Configuration FG 2-position Number of Solenoid Subplate (NPTF) FHG 3-position, Closed center FJG 3-position, Exhaust center Without Subplate A02T Side 1/4 For VSR/S8-6 S Single D Double FIG
UTC SPECIAL DESIGN. 1"x1"x1" NPT PVC Tee Fitting. 0.22600 lb. H41.
The cost effective and clean looking AC series allows you to pick a combination of modular style air preparation equipment that best suits your needs. The series, available in 8 size options to ensure optimum performance, offers energy savings, with higher flow rates. Simple assembly and maintenance reduces downtime. Pressure relief, 3 port valve, Accessory for AC series, Body sizes: 1/8
Regulator Unit Combination: [Other FRL Combination Devices] Other FRL Combination Device, Port Size: Rc3/4, Compressed Air Quality: General Dry Air, Maximum Operating Pressure(MPa): 1, Case Material: [Resin] Polycarbonate Case, Case Guard: Presence, Exhaust Structure: Relief type, Flow Direction: [Standard Flow (Left to Right)] Left to right, Drain Cock: [Not Provided] No, Pressure Gauge: