3 Position Cylinder Series RZQ If the cylinders are moved from the retraction end to the extension end or vice versa without stopping in the intermediate position, the operation of piston B will become unstable and the occurrence of abrasion may be accelerated due to contact with other parts. Guide Shock absorber Floating joint 3 position cylinder Selection 6.
Stopping the handle halfway between the extreme positions may cause malfunction. VHS 5-8-15
Applying incorrect voltage may cause a malfunction or a burned coil. 4. Connect the wires so that an external force of greater than 10 N is not applied to the lead wire. Otherwise the coil will burn. 5. Units with power-saving circuits use polarized electrical connections.
(Using a non-sensitive regulator may cause unstable pressure.) (External pilot solenoid valve) (Relieving type regulator) The large capacity relief valve rapidly responds and sets the balance pressure. Solenoid on/off operation drives the cylinder.
Limited warranty and Disclaimer The warranty period of the product is 1 year in service or 1.5 years after the product is delivered.*3) Also, the product may have specified durability, running distance or replacement parts. Please consult your nearest sales branch.
Operation with the max. thrust may cause the electric cylinder rod to move suddenly.
Also, the product may have specified durability, running distance or replacement parts. Please consult your nearest sales branch. 2. For any failure or damage reported within the warranty period which is clearly our responsibility, a replacement product or necessary parts will be provided.
If the case is cracked, this may lead to a serious accident, such as case rupture. So, replace the case immediately and locate the cause. If the case is contaminated significantly and the internal status cannot be checked, clean the case with neutral detergent.
(Tolerance 30%) Hysteresis may fluctuate due to the operating environment.
However, depending on the number of switches in the ON state, the indicator lights may sometimes dim or not light up, because of dispersion and reduction of the current flowing to the switches.
Lack ot contact protection may cause a reduction in switch service life. 2.
Shock absorber or urethane bumper may not operate effectively and damage may result. 138 138 Long Stroke Slide Table MXW Series Optional Specifications Shock Absorber Specifications RB0805 RB0806 RB1007 RB1412 RB2015 Shock absorber model MXW8 MXW12 MXW16 MXW20 MXW25 Suitable slide table 0.98(0.1) 2.94(0.3) 5.88(0.6) 19.6(2) 58.8(6) Max. absorbing energy J (kgf m) 5 6 7 12 15 Absorbing stroke
If operated outside of this range, the suction lifting height may not reach the prescribed value.
If operated outside of this range, the suction lifting height may not reach the prescribed value.
However, depending on the number of switches in the ON state, the indicator lights may sometimes get dark or not light up, because of dispersion and reduction of the current flowing to the switches.
Home position switch Photo micro sensor EE-SX672 Model Note 2) Since vibration may increase with low speed operation, use 6mm/s or more as a guide for speed. LC6D-507AD (Refer to page 306 for details.)
Switch output may malfunction. 3. Wire separately from power lines and high voltage lines, avoiding wiring in the same conduit with these lines. Malfunctions may occur due to noise from these other lines. 4. If a commercial switching regulator is used, make sure that the F.G. terminal is grounded. Mounting Caution 1.
Individual drawings for specific made to order models may not be available. Consult SMC separately if drawings are needed.
When the sensitivity is increased, hunting may occur. When the sensitivity is decreased, hunting will be reduced, but the pressure correction will be reduced, so there may be a moderate pressure instability.
Mount 72 Periodic check 71 Daily check Feeding screw sliding part L[]ZB[]5[] L[]Z[]5H 73 Life Actuator may have sudden movement if operated with max. torque.