2/3 Port Valve (P2+0.1013) Calculation by Cv factor Q=1972.8.Cv.
The circulating fluid is sent to the evaporator by the inverter pump, and is controlled to a set temperature by the refrigeration circuit, to be discharged to the users equipment side again by the thermo-chiller.
Shallow scratches caused by sliding 1. Inside surface of tube Deep scratches Caused by sliding Replace it with new one when it cant be repaired. Scratches caused by seizing Replace with new one. Sliding face of rod Stripping Replace with new one. No problem with operation. Rub them with paper, etc. slightly. Shallow scratches caused by sliding 2.
Has large retaining force while holding force is increased by the collet.
Configuration Minimum equipment and wiring requirements to get started 1 7 Provided by customer 100V AC /200 V AC Provided by customer 24 VDC Provided by customer 8 2 PC 6 4 Electric Actuators Ex) LEF Provided by customer 3 1 Driver LECSA*-S* 2 Motor cable LE-CSM-*** 3 Encoder cable LE-CSE-*** 4 I/O connector LE-CSNA I/O cable LEC-CSNA-1 5 USB cable LEC-MR-J3USB 6 Setup software (MR Configurator2TM
Mounting freedom is improved by providing T-slots on the mounting surfaces When used for picking and placing, etc.
The set pressure of the relief valve should not be adjusted (or changed) by the user.
1 manually counterclockwise lowers piston u, which pushes open the seal created by seal !
Minimum operating pressure reduced by 30% By using a soft wiper the minimum operating pressure is reduced by 30%. (comparing CY3B40 and CY1B40) Improved lubrication by using a soft wiper A special resin soft wiper is installed on the dust seal to achieve a ideal lubrication on the external surface of the cylinder tube.
The circulating fluid is sent to the evaporator by the inverter pump, and is controlled to a set temperature by the refrigeration circuit, to be discharged to the users equipment side again by the thermo-chiller.
In the case of the return to origin by pushing force, additional force will cause displacement of the origin position since it is based on detected motor torque. 6. Do not remove the nameplate. 7. Operation test should be done by low speed. Start operation by predefined speed after confirming there is no trouble. 8.
Application: The supply pressure is controlled by electric signals and a vacuum release is effected by external air.
The dimension is added by 21 mm at 1 piece addition.
Produced by Mitsubishi Cable Industries, Ltd.
T nuts provided by P/A.
Run / stop by contact input. Set circulating fluid temperature by serial communication. To display the "SERIAL (DIO Run)". DIO by pressing it.
=The anti-freezing function is ensured by the intervention of the hot gas by-pass solenoid valve signalled by the on the DMC11. Switching off : =Verify that the DewPoint displayed on the DMC11 is correct. =Switch off the air compressor. =After few minutes, switch off the main switch on the control panel of the dryer (pos. 1).
1 2 7 Eiector size determination by calculation: '1 .
1 2 7 Eiector size determination by calculation: '1 .
Turns ON when the set value is reached Return to the set value by reset. Normal output Time Accumulated decrement output mode Count down from set value. Turns ON when 0 is reached. Return to the set value by reset.