Magnet: Built-in Magnet, Series: Standard, Head Cover Type: Double End Boss-cut, Bore Size: 40mm, Stroke: 250mm, Cushion: Rubber Bumper, Standard, Rod Boot: w/o Rod Boot, Mounting Bracket: None, Accessory: None, Auto Switch Mounting Type: Rail Mounting, Auto Switch: -, Lead Wire or Prewired Connector: -, Number: -

Magnet: Built-in Magnet, Series: Standard, Head Cover Type: Double End Boss-cut, Bore Size: 40mm, Stroke: 50mm, Cushion: Rubber Bumper, Standard, Rod Boot: w/o Rod Boot, Mounting Bracket: None, Accessory: None, Auto Switch Mounting Type: Rail Mounting, Auto Switch: -, Lead Wire or Prewired Connector: -, Number: -

Magnet: Built-in Magnet, Series: Standard, Head Cover Type: Double End Boss-cut, Bore Size: 40mm, Stroke: 125mm, Cushion: Air Cushion, Rod Boot: w/o Rod Boot, Mounting Bracket: None, Accessory: None, Auto Switch Mounting Type: Rail Mounting, Auto Switch: -, Lead Wire or Prewired Connector: -, Number: -

Antistatic Tubing TA  Series

The minimum bending radius indicates the value at a temperature of 20C with an outside diameter rate of change of 10% or less. 3. Please exercise caution when using this item in a clean room.

Table of Contents

(VX31, 32, 33) 20 Model Minimum AC/DC Ambient temperature (C ) 40 10 Operating fluid temperature (C ) Temperature conditions Power source Sketch Air Vacuum 60 10 40 AC/DC Maximum AC/DC 20 Minimum Position ON X X P A P A X OFF X X A R (VP) A R X ON X X A R (VP) X A R OFF X X P A X P A ON Pq A A Pq Pq A Pq A A Pq OFF Pw A A Pw Pw A A Pw Pw A Note 1) An exclusive type set with

Free Mount Cylinder

Although a zener diode for surge protection is connected at the output side of a solid state auto switch, damage may still occur if a surge is applied repeatedly. When directly driving a load which generates a surge, such as a relay or solenoid valve, use a switch with a built-in surge absorbing element. 7.

Refrigerated Air Dryer

Do not use this product on board a vehicle or a vessel. This product must not be installed and used on board a conveyance such as a vehicle or a vessel, as it may become damaged due to vibration. If it must be used in such a manner due to unavoidable circumstances, please contact SMC beforehand. 1.

53

Use this as a reference.

KJ

D Can be used for a wide range of pressures from a low vacuum up to a pressure of 1.0 MPa The use of a special profile ensures sealing and reduces resistance when the tube is inserted.

Series KV2 Fittings

Dont use a wrench on push-to-connect end. 2 2 Cut tubing square with a clean 90 edge Dont use excessive tube angle cut which can lead to leakage or breaking. 90 90 3 3 Use SMC Tube Cutters Dont use dikes, a knife, a saw or a dull tool to cut the tubing.

Table of Contents

(A contact) N.O. (A contact) Specifications N.O. (A contact) N.O.

Table of Contents

Turn cover A counterclockwise until it stops (approx. 45). 4. Install a new element on cover A and insert it into the case. Cover A Case Cover A Case O L L Element O-ring Window 5.

Electric Actuator with Integrated Guide

Model Allowable Moment (Nm) Allowable dynamic moment Model Mounting orientation Load movement direction LTF6 200 Horizontal/Lateral Horizontal/Lateral Lateral Horizontal a Mep L1 (mm) Pitching 100 m a=1000 a=2000 a=3000 L1 30 20 10 0 Transfer load m (kg) L2 200 a=1000 a=2000 a=3000 Mer L2 (mm) Rolling Yawing 100 m L2 Mer 30 20 10 0 m Transfer load m (kg) 200 a=1000 a=2000 a=3000 L3 (mm) 100

Controller/Driver LEC/JXC Series <Single Axis Controllers> Step Data Input Type Page 560 Gateway Unit Page 572 Programless Type Page 576 Step Motor LEC-G Series Step Motor Servo Motor (Servo/24 VDC)/ (Servo/24 VDC)/ (24 VDC)/ LECP6 Series LE

Shield Brown Black Red Black Orange Black 12 13 7 6 9 8 3 Vcc GND A A B B B-4 A-4 B-5 A-5 B-6 A-6 LE-CP-3-B 360 LE-CP-5-B 590 LE-CP-8-B 1060 LE-CP-A-B 1320 LE-CP-B-B 1920 LE-CP-C-B 2620 Robotic cable Connector B terminal no.

Integrated Controller

B A A B B-B In-line motor Component Parts Component Parts (Top/Right/Left side parallel only) No.

Secondary Batteries

Compatible with a low dew point (40C). Using a vacuum port for vacuum suction enables reducing more dust particles than 90series.

Bernoulli Gripper

Consider selecting a ZNC series (body size 20) Bernoulli gripper as a substitute. Click here for details. A type with a mounting plate has been added. For the adsorption transfer of thin cloths, films, printed circuit boards, etc.

25

Avoid using in a place that exceeds an ambient temperature range. b. Avoid using in a place that exceeds an ambient humidity range. c. Avoid using in a place where condensation occurs due to a drastic temperature change. d. Avoid using in a place in the presence of corrosive or explosive gas or where there is a volatile combustible. e.

Dedicated Controller

MS-DOS is a registered trade mark of Microsoft Corporation. Pentium is a trade mark of Intel Corporation.

Dedicated Controller Series LC1 Uniaxial Type

Windows Edition Operating environment Model: LC1-1-W1 A model with a Pentium 75MHz or faster CPU, and able to fully operate Windows 95. Computer Windows 95 16MB or more 5MB of disk space required OS Memory Disk drive Windows is a registered trade mark of the Microsoft Corporation. Pentium is a domestic trade mark of the Intel Corporation.