Smooth Cylinder/Low Speed Cylinder Mounting pitch L (mm) Bore size (mm) 10 16 20 25 32 30 33 40 46 56 Dimensions of shielding plate (MU-S025) that is sold separately are indicated as reference.
When the piston speed exceed 750 mm/s, make sure that direct impact does not apply on the cylinder cover by using an external stopper (shock absorber, etc). Standard external (B) 17 25 35 36 46 60 70 86 100 Dimensions except mentioned above are the same as standard type.
IC chips With adapter Single unit Nozzle 0.8, 1.1 P. 9 AN Thin Flat Pad For adsorption of soft work pieces such as thin sheets or vinyl.
Equipment such as an ejector is configured as an individual unit. Thus, it is possible to create a flexible system configuration in which the circuit composition and the mounting locations can be selected as desired.
An external pilot style that can be used individually is available as a made-to-order. For details, refer to the page 4-6-46.
Dedicated grounding should be used as much as possible. Grounding should be to a type 3 ground. (Ground resistance of 100 or less.) 3. Grounding should be as close as possible to the controller, and the ground wires should be as short as possible. 4. In the unlikely event that malfunction is caused by the ground, it may be disconnected. 1. Wiring should be properly completed.
Provide an intermediate support for a cylinder with a long stroke. If the cylinder has a long stroke, provide an intermediate support to prevent the rod from sagging and the tube from flexing, as well as to prevent damage to the rod due to vibrations or external loads. Mounting Caution 1. Be sure to connect the rod and the load so that their axial center and movement directions match.
When directly driving a load which generates a surge, such as a relay or solenoid valve, use a switch with a built-in surge absorbing element. 7. Cautions for use in an interlock circuit When an auto switch is used for an interlock signal requiring high reliability, devise a double interlock system to safeguard against malfunctions.
Note) When placing an order for body ported solenoid valve as a single unit, mounting bolt for manifold and gasket are not attached.
Since no protective cover is installed on the product, provide an external protective cover protecting the entire product wherever possible. Using the product in an environment where it is exposed to water, liquid coolant or dust such as iron powder will cause an adverse effect to the ball screw and the guide. Therefore, an external cover is also required for dust prevention. 8.
When designing an application, be sure to allow sufficient space for maintenance and inspection. In cases of high piston speed, the use of an auto switch (DF5NT/F7NT/G5NT and M5T) with a built-in OFF delay timer ( 200 ms) makes it possible to extend the load operating time. 4. Wiring should be kept as short as possible.
IC chips With adapter Single unit Nozzle 0.8, 1.1 P. 9 AN Thin Flat Pad For adsorption of soft work pieces such as thin sheets or vinyl.
Do not use an air cylinder as an airhydro cylinder. If it uses turbine oil in place of fluids for cylinder, it may result in oil leakage. 4. The oil stuck to the cylinder is grease. 5. The base oil of grease may seep out.
Since no protective cover is installed on the product, provide an external protective cover protecting the entire product wherever possible. Using the product in an environment where it is exposed to water, liquid coolant or dust such as iron powder will cause an adverse effect to the ball screw and the guide. Therefore, an external cover is also required for dust prevention. 8.
This function prevents detection of such temporary drops in the supply pressure as an error by changing the delay time setting.