The tubing (O.D.: ø12, Length: 20 cm) that comes with the HEP500-04 should be connected to the OUT side of the fluid collector. Be sure to connect the included ø12 tube to the fitting, making sure that the tube tip does not enter the tank liquid. <br>※Use only 1 strainer per collector. <br>※There is also the PA series process pump for cutting oil collection.

<br><br>

Rubber Seal, 5 Port Solenoid Valve, Series SZ3000

3 position Valve effective sectional area mm (Cv factor) 3.2 (0.18) [3.2 (0.18)] Maximum 50 PA/B Ambient and fluid temperature C 3.7 (0.21) [3.2 (0.18)] C6 A/BR 3.9 (0.22) [3.8 (0.21)] 2 position single, double Maximum operating frequency Hz 10 4 position dual 3 port valve PA/B 3.4 (0.19) [3.2 (0.18)] M5 A/BR 3 3 position 3.2 (0.18) [3.2 (0.18)] Weight W (g) Note 3) Non-locking push type

<br>USB drivers for communication cables (LEC-W2A-C and LEC-W2-C) can also be downloaded. <br>The controller setting software can be downloaded from here. <br>Note) Even if you download the controller setting software, a communication cable (LEC-W2A-C) or USB cable (LEC-W2-U) is always required.

<br><br>

<br><br>

<br>In order to properly stop at 180°, an external stopper must be installed.<br>Sizes 20, 30 and 40 of the new CRB series released in November 2018 can be adjusted by ±5° on 1 side (start or end point) as standard.<br>Please consider using the CRBS20-180. CRB2 series rotary actuators with an angle adjuster unit also allow for the angle to be adjusted to 180°.

<br>Note 2) For old AF, AFM, AFD, and AW series products (4 digits: AF□□□□), as the resin bowl can be expected to deteriorate after 20 years of use, replacement with the current product is recommended.<br>Element model No.

<br>④ The pipe length from the strainer to the liquid collector body is 20 m or more when the mounting height of the liquid collector is 3 m or more for a water-soluble solution or 1 m or more for an insoluble solution. <br>⑤ The dynamic viscosity of the fluid is too high to flow. <br>⑥ The operating fluid is air. (Air cannot be used as the fluid.

<br><br>

<br>1 angle adjuster unit is required for retrofitting to an actuator without an auto switch unit.<br>When retrofitting to an actuator with an auto switch unit, 1 angle adjuster unit and 1 joint unit are required.<br>Sizes 20, 30, and 40 of the new CRB series released in November 2018 can be adjusted by ±5° on 1 side (start or end point) as standard.

<br>Note 2) For AF10/20 series air filter bowl assemblies, remove the bowl assembly by turning it counterclockwise.

<br>Note 2) The data used in the “Compatibility Checklist for Used Materials and Fluids” was collected at room temperature (20°C). <br>The KQG2 series catalog can be found here.

<br>・AMC220, AMC310, and AMC320: 20 mm<br>・AMC510 and AMC520: 35 mm<br>・AMC610: 60 mm<br>・AMC810: 110 mm<br>・AMC910: 140 mm

<br>Note that neither is included with the controller. The part number of the teaching pendant is “LEC-T1-3JG(S).” <br>The controller setting software was formerly a CD-ROM (sold separately), but it can now be downloaded from the SMC website. <br>The controller setting software can be found here.

Replace the element after 1 year of use or when one of the following occurs: <br>① When the pressure drop reaches 20 kPa at negative pressure:<br>ΔP(20 kPa) ② When the time until the vacuum pressure is reached is longer than the set time of the device: <br>set time (T) ③ When there are no remarkable changes in the operating environment conditions (vacuum ÷ release frequency, dust amount,

For the -20°C (-15°C) specification, the atmospheric dew point reaches -20°C (-15°C) in about 10 minutes after air is supplied.<br>The low dew point type requires 30 to 60 minutes.<br><br>

<br>A video demonstrating normally closed ON/normally open OFF can be found here.<br>A video demonstrating normally closed OFF/normally open OFF can be found here.

TABLE OF CONTENTS

Series 20, 30 2 W.N.C. & All 3 W. 2 W.N.O. 30, 50, 70 Series 20 Series 20, & All 3 W. & E20 & 30 50, 70 & E20 Series 20 Media S.S. Body Brass Body S. S.