E-P HYREG ® Series VY1

-6 1 1 1 0 2.5 5 7.5 10 0 2.5 5 7.5 10 0 2.5 5 7.5 10 V V V VY130-7 VY140-7 VY150-7 2 2 2 4 0 8 12 16 20 mA 4 0 8 12 16 20 mA 4 0 8 12 16 20 mA VY130-8 0 5 10 15 20 VY140-8 0 5 10 15 20 VY150-8 0 5 10 15 20 3 3 3 mA mA mA Command signal Command signal Command signal VY1700 1 VY1900 1 Input signal voltage (current) for starting the operation of a pilot valve VY1D0 (direct operated) (There

Cylinder with lock

Apply grease to the seal groove and outer circumference by rubbing grease into them as shown in Fig. 20. 3) Tube gasket ( in Fig. 18) Install with care not to twist the tube gasket. A little less than 1 mm Fig. 19. Rod seal Fig. 20.

10

1/RJ20 70 140 20 RJ2015L RJ2725L RJ1412L 60 120 Impact mass m [kg] Impact mass m [kg] Impact mass m [kg] 15 100 50 RJ2725H RJ1412H 80 40 RJ2015H 10 60 30 RJ1410 40 20 5 20 10 0 0 0 0 500 1000 1500 2000 0 500 1000 1500 2000 0 500 1000 1500 Collision speed [mm/s] Collision speed [mm/s] Collision speed [mm/s] 882 Model Selection RJ Series Model Selection Graph The model selection graphs

VQ7-6/7-8

Do not use valves in atmospheres of corrosive gases, chemicals, salt water, water or steam, or where there is direct contact with same. 2. Do not use in an explosive atmosphere. 3. Do not use in locations subject to vibration or impact. Confirm the specifications for each series. 4. A protective cover, etc., should be used to shield valves from direct sunlight. 5.

CKZ2N

22 8.5 R7 22 20 NAAMS code K NAAMS code K Part no.

Air Cylinder

1) Tighten the retaining screws to an appropriate tightening torque within the range given below. 10: 10.8 to 11.8 Nm, 16: 20 to 21 Nm 2) Do not operate it in such a way that rotational torque would be applied to the piston rod.

Cylinder with lock

Apply grease to the seal groove and outer circumference by rubbing grease into them as shown in Fig. 20. 3) Tube gasket ( in Fig. 18) Install with care not to twist the tube gasket. A little less than 1 mm Fig. 19. Rod seal Fig. 20.

IDX-OM-Y002

Do not connect the earth to a water pipe, a gas pipe, or a lightening rod. Do not plug too many leads into a single socket. That causes exothermic heat or fire. Do not modify the internal electrical wiring of the product. 10.2 Specifications An earth leakage breaker is installed in the product.

CJ2

Refer to pages 6-20-3 to 6-20-6 for Safety Instructions and Actuator Precautions.

Compact

20 20 65 28 27.3 25A(28) 27 20 Motor cable length 300 102 0.3 LEC 7.5 LEC S Note 1) [ ] for when the direction of return to origin has changed.

Gun Type Ionizer

Do not use the AC adapter for the DC power supply of a different product.

Handheld Electrostatic Meter

Caution Avoid strong impact on the product Do not drop, hit or apply excessive shock to the product while handling. It can cause failure. Do not contact the sensor with the measured target. It can cause failure. Do not handle with wet hands. This can cause electric shock. Provide grounding to ensure safety and accurate measurement.

VCW

Do not use valves in atmospheres of corrosive gases, chemicals, salt water, water or steam, or where there is direct contact with same. 2. Do not use in an explosive atmosphere. 3. Do not use in locations subject to vibration or impact. 4. Do not use in a location where radiated heat will be received from a heat source in the vicinity. 5.

Low Friction Cylinders Series MQ

, but unassembled. 30 10, 20, 30, 40, 50, 75, 100 40 10, 20, 30, 40, 50, 75, 100 Bore size Strokes are available in 1 mm increments by installing a spacer in standard stroke cylinders. 10 16 20 25 30 40 10 mm 16 mm 20 mm 25 mm 30 mm 40 mm Port thread type M thread Rc NPT G 10 to 20 Nil 25 to 40 TN TF The MQQ series is not auto switch capable.

CJ2

(mm) Material: Iron A 15 15 CX 3.2 6.5 BA 12 18 GB 18 23 BB 12 18 H 20 20 CD(cd) 3.3 5 CA 14 20 KA 4.2 5.2 CB 14 20 MM M4 X 0.7 M5 X 0.8 NA 5.5 5.5 NB 22.5 27.5 R 5 8 U 8 10 Part No.

MK

Operating range RB Model C 8 8 8 8 D 50 60 50 60 75 85 75 85 85 95 75 85 95 130 100 130 Mounting bolt M3 x 50l M3 x 60l M3 x 50l M3 x 60l M5 x 75l M5 x 85l M5 x 75l M5 x 85l M5 x 85l M5 x 95l M5 x 75l M5 x 85l M6 x 95l M6 x 130l M8 x 100l M8 x 130l MKB12-10 MKB12-20 MKB16-10 MKB16-20 MKB20-10 MKB20-20 MKB25-10 MKB25-20 MKB32-10 MKB32-20 MKB40-10 MKB40-20 MKB50-20 MKB50-50 MKB63-20 MKB63-50

Digital Pressure Switch

Safety Instructions Warning Do not disassemble, modify (including changing the printed circuit board) or repair. An injury or failure can result. Do not operate the product outside of the specifications. Do not use for flammable or harmful fluids. Fire, malfunction, or damage to the product can result. Verify the specifications before use.

T

Material Polyolefin (Equivalent to UL-94 standard V-0) 0 20 0 20 40 60 Note) The color of all inner tubing is black.

In-line Air Filter

20 20 0.5 MPa 0.7 MPa 0.7 MPa 0.7 MPa 10 10 10 0 0 0 5 10 15 0 0 10 20 30 40 60 50 0 10 20 30 40 50 Flow rate [L/min (ANR)] Flow rate [L/min (ANR)] Flow rate [L/min (ANR)] ZFC33/3B 4, 5/32" ZFC53/5B 4, 5/32" ZFC54/5D 6, 1/4" 0.3 MPa 0.3 MPa 0.3 MPa 30 30 30 0.1 MPa Pressure drop [kPa] Pressure drop [kPa] Pressure drop [kPa] 0.1 MPa 0.1 MPa 20 20 20 0.5 MPa 0.5 MPa 0.5 MPa 0.7 MPa 0.7 MPa

Stainless Steel Heat

x 3 x 60 = 2736g/h. 6 7 8 3 1 2 3 4 5 Dew point conversion chart 60 50 40 30 Pressure dew point C 20 10 1.5MPa 1.3MPa 1.1MPa 0.9MPa 0.7MPa 0.5MPa 0.3MPa 0.1MPa Atmospheric pressure 0 -40 -30 -20 -10 -60 -50 -60 -50 -40 -30 -20 -10 0 10 20 30 Atmospheric pressure dew point C 8 Series IDUS/IDFS Safety Instructions These safety instructions are intended to prevent a hazardous situation and/