Rotary Actuator NCRB1BW Series Single Vane / Double Shaft

Corxtruction./ Parts List 27A' PartsList Note: The rotation specilication of270', the point of minimum rotation 20' is a limit shifring point even il the switch is shifted to make rotation of switch as shown in the left diagram. (E\ren if switch is shitted tothe maximum, switchon will be made at the point prior to the stopping ooint at 20'.)

VCW

Note 3) When using seal material PTFE at 15 cm3/min (under water pressure) or less. Note 4) Vibration resistance Conditions when tested with one sweep of 10 to 250 Hz in the axial direction and at a right angle to the armature, in both energized and deenergized states. No malfunction occurred when tested (value at the initial state).

For Dry Air, Pilot Operated Series VQ20/30 2 Port Solenoid Valve

Turn it in the counter-clockwise direction at 90o, and it is locked. Turn it right to release. 3.8 Change of electrical entry Wire entry can be changed by mounting the housing in either direction (four directions at every 90) after dividing the terminal block and the housing. For the indicator lighted style, be careful not to damage the light with the lead wire of the cable.

NCRBIBwserbs

Corxtruction./ Parts List 27A' PartsList Note: The rotation specilication of270', the point of minimum rotation 20' is a limit shifring point even il the switch is shifted to make rotation of switch as shown in the left diagram. (E\ren if switch is shitted tothe maximum, switchon will be made at the point prior to the stopping ooint at 20'.)

Large Size 3 Port Solenoid Valve VP3145/3165/3185 Series Rubber Seal

Test was performed at both energized and de-energized states in the axial direction and at the right angles to the main valve and armature.

ITVH

mA DC, 0 to 20 mA DC (Sink type) Voltage type 0 to 5 VDC, 0 to 10 VDC Input signal Preset input type 4 points (Negative common) Current type 500 or less Voltage type 6.0 to 6.5 k (at 25C) Input impedance Preset input type Approx. 4.7 k 1 to 5 VDC Output impedance: 1 k or more Output accuracy: 6% F.S. or less Analog output Symbol 4 to 20 mA (Sink type) Output impedance: 250 or less Output

IDX-OM-Y002

Auto drain Check the auto drain is working properly at least once a day.

Table of Contents

to cylinder, Needle fully open (2) Load ratio {(Load weight x 9.8) Theoretical output} x 100% Speed at the end (u) Time (s) SOL: ON(OFF) 1-2-4 1-2-5 4 Series SV Air Cylinders Drive System Full Stroke Time and Speed at the End Air Cylinders Drive System Full Stroke Time and Speed at the End Series SV3000 Applicable bore size: 50, 63, 80, 100 Series SV4000 Applicable bore size: 63, 80, 100

AS-FG/ASD-FG

AS121FG-M5 AS231FG-01 R(PT) 1/8 20, 25, 32 AS221FG-01 AS231FG-02 R(PT) 1/4 20, 25, 32, 40 AS221FG-02 AS331FG-02 R(PT) 1/4 40, 50, 63 AS321FG-02 AS331FG-03 R(PT) 3/8 40, 50, 63 AS321FG-03 AS431FG-04 R(PT) 1/2 63, 80, 100 AS421FG-04 AS131FG-U10/32 10-32UNF 6, 10, 16, 20 AS121FG-U10/32 AS231FG-N01 NPT1/8 20, 25, 32 AS221FG-N01 Elbow type AS231FG-N02 NPT1/4 20, 25, 32, 40 AS221FG-N02 AS331FG-N02

1 High Purity Chemical Valve Compact Type Series LVD VC
Space saving, compact type is available. Space saving, compact type is available. VDW Compact type is introduced as a new series to complement VQ Body: New PFA Body: New PFA Body: New PFA conventio

0 Insert pin assembly replacement screw Cut the end of the tubing y at a right angle and pass it through the fitting nut u.

Centering Unit

] 10 2250 lbf [10 KN] Relief port Nil No V Yes Stroke Sensor type Symbol Stroke (Applicable model) 12 12 mm (MACM2) 20 20 mm (MACM4) 30 30 mm (MACM6) 50 50 mm (MACM10) Nil Unsupported P Port side photo sensor mounted type B Port back side photo sensor mounted type Specications Precautions Model MACM2-12 MACM4-20 MACM6-30 MACM10-50 Max. allowable load weight lbf [KN] 450 [2] 900 [4] 1350 [

EXxx-OMW0014CN

EX245-LA1/LB1 . 9-8 StandardIO -Proceed -Shutdown, Clear value () -Shutdown, Hold last state Power supply and I/O value at pause (PROFIenergy) SI PROFIenergy .4-11 . 9-9 Digital output Force to OFF () OFF Output operation at network fault PROFINET Force to ON ,ON Hold last state . 9-10 IO-Link Device OFF Clear / PD Out valid IO-Link Valid() IO-Link device operation at network fault

MGP-OM0242Q

Auto switch proper mounting position (detection at stroke end) and Its mounting height 14-3. Minimum mountable stroke for a cylinder with auto switch(es) (mm) Auto switch model Number of auto sw itches 12 16 20 25 32 40 50 63 1pc. D-M9 5Note1) 5 2pcs. 10Note1) 10 1pc. D-M9W 5Note2) 2pcs. 10Note2) 10 1pc.

Mist Separator Series AM Model Series AM can separate and Model AM850 AM250 AM350 AM450 AM550 AM650 AM150 remove oil mist in compressed air Rated flow 750 1500 2200 3500 6000 12000 300 (1) (l/min (ANR)) which is difficult to remove by Port size ordin

O 54 66 66 80 80 88 88 102 136 P 70 84 84 100 100 110 110 130 180 Q 26 28 28 34 34 50 50 60 76 R 45 5 5 5 5 9 9 10 12 S 1.6 2.0 2.0 2.3 2.3 3.2 3.2 4.5 4.5 T U 37 37 37 37 37 37 37 37 37 AFF 159 172 178 204 210 225 232 259 311 13 13 16 16 19 19 22 22 32 100 113 119 145 151 166 173 200 253 63 76 76 90 90 106 106 122 160 20 20 20 20 20 20 20 20 20 63 76 76 90 90 106 106 122 160 24 27 27 32

KK/KK13

Moreover, position the wrench at the lower part of the hexagonal flats as close to the threads as possible. When a wrench of the proper size for the hexagonal flats is not used, it will cause the hexagonal flats to wear down. 3.

ZP

Rotating, K: Non-rotating Stroke [mm] 10, 20, 30, 40, 50 10, 20, 30, 50 Connection thread M10 x 1 M14 x 1 Spring reactive force [N] At 0 stroke 1.0 2.0 At full stroke 3.0 5.0 30 Basic Pad Flat Type ZP Series How to Order Dimensions/ Models Construction Mounting Bracket Assembly ZP 02 U N p. 32 p. 115 p. 117 From p. 121 Pad unit Pad units sales unit: 10 pcs.

Slider Type Ball Screw Drive/11-LEFS Series

8 12 16 20 24 0 10 20 30 40 50 0 0 2 4 6 8 10 12 14 16 0 10 20 30 40 50 60 Work load [kg] Work load [kg] Work load [kg] Work load [kg] 1000 1000 1000 1000 800 800 800 800 L6 L6 [mm] L6 [mm] L6 [mm] L6 [mm] 600 600 600 600 Z 400 400 400 400 200 200 200 200 0 0 4 8 12 16 20 24 0 0 0 0 2 4 6 8 10 12 14 16 0 10 20 30 40 50 0 10 20 30 40 50 60 Work load [kg] Work load [kg] Work load [kg] Work

AMG

150 H 166 187 187 218 218 241 241 277 334 1/8, 1/4, 3/8 1/4, 3/8 1/2 3/8, 1/2 3/4 1/2, 3/4 1 3/4, 1 1, 11/2 5.5 6 6 7 7 9 9 9 11 10 10 10 10 10 10 10 10 10 63 76 76 90 90 106 106 122 160 20 20 20 20 20 20 20 20 20 63 76 76 90 90 106 106 122 160 100 113 119 145 151 166 173 200 253 13 13 16 16 19 19 22 22 32 159 172 178 204 210 225 232 259 311 AMG150 AMG250 AMG350 AMG450 AMG550 AMG650 AMG150

Plate Cylinder with Lock Series MLU

8 B At the time of shipment @7 Retraction locking C M(D)LUB25 Parts list No. 1 2 3 4 5 6 7 8 9 10 11 12 Description Material Note Description Material Note No. 15 16 17 18 19 20 Hexagon socket head cap bolt B Stainless steel Aluminium alloy Hard anodized Lock body Hexagon socket head cap bolt C Stainless steel Aluminium alloy Hard anodized Cover Hexagon socket head cap bolt D Head cover Nickel

Non-rotating Double Power Cylinder/ Double Power Cylinder (without non-rotating mechanism) Series MGZ/MGZR ø20, ø25, ø32, ø40, ø50, ø63, ø80, ø100 1

Power Cylinder Series MGZR 20, 25, 32, 40, 50, 63, 80 Non-rotating Double Power Cylinder Series MGZ 20, 25, 32, 40, 50, 63, 80 Double extension output power (without non-rotating mechanism) 20 are 20 are and 25 sizes newly added. and 25 sizes newly added.