IR30-OM00013

No.I R30-O M 00013A / Series IR3000 IR3010 IR3020 23 1. 4 2. 5 3. 6 4. 6 5. 710 6. 10 7. 11 8. 12 -1- (ISO/IEC)(JIS) *1) *1) ISO 4414: Pneumatic fluid power -General rules relating to systems ISO 4413: Hydraulic fluid power -General rules relating to systems IEC 60204-1: Safety of machinery -Electrical equipment of machines (Part 1: General requirements) ISO 10218-1992: Manipulating industrial

Precision Regulator

Recommended tightening torque (Nm) Thread size 1/4 Torque 12 to 14 -9- (2) Do not apply torsion or bending moment other than the weight of the product itself.

ITV-E

I TV2O M 00068C 12

Profi-E

S. ) , O ccupi ed byt e : 2 Byt e Target val ue ( 0 area) 12bi t 0 0 0 0 Target value(Lower 12 bits) * b0 b15 b11 Put 0 i n upper 4 bi t s ( N ot e) M oni t or t he out put pressure. Resol ut i on : 12bi t ( 100% F.

DOC1019547

Description Material Note 1 Body A PBT 2 Body B PBT 3 Needle PBT 4 Indicator 5 Stopper Stainless-steel 6 Needle guide Brass Electroless nickel Plated 7 Disk seal HNBR 8 Stud Brass Electroless nickel Plated 9 O-ring NBR 10 O-ring NBR 11 O-ring NBR 12 O-ring 13 Seal NBR 14 Gasket NBR/Stainless-steel 15 O-ring NBR Meter-in type only 12 - Doc.no.DOC1019547 Seal method/Sealant For R,NPT Seal method

PSxx-OMP0001E

This may damage the pressure sensor, leading to malfunction. 25.5 Brown OUT(+) Load PS1000/PS1100/PS1200 + Main circuit of switch 12 to 24 VDC AIRCHECKER + PS1000-R06L 13 PRESS. -0.10.45MPa {-14.6kgf/cm2} MADE IN JAPAN G Thank you for purchasing the SMC PS1000/PS1100/PS1200 Series Air Checker: Electronic Pressure Switch.

EXxx-OMA1018_Eng

SWEDEN (46) 8 603 12 00 Caution Ekhagsvgen 2931, SE-141 71 Segeltorp, Sweden Refer to the SMC website (URL https://www.smcworld.com) to obtain more detailed information about maintenance. Notice: Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment.

VF1000-OMP0001

No.VF1000-OMP0001 5 VF1000/3000/5000 / / / / -2, 3 / -4, 5 -5 -6 -6 -6 -6, 7 -7 -7 -810 -11 -12 1 VF1000-OMP0001 (ISO/IEC)(JIS) *1) *2) *1) ISO 4414: Pneumatic fluid power -General rules relating to systems ISO 4413: Hydraulic fluid power -General rules relating to systems IEC 60204-1: Safety of machinery -Electrical equipment of machines (Part 1: General requirements) ISO 10218

VP(A)300/500/700 Series (PILOT VALVE : V200)

If the fitting within the applicable range is selected, there will not be any interference. 12 No.VP300-OMM0002-A TROUBLE SHOOTING Should any trouble be found during operation, trace the source of the trouble in the following order and take corrective action.

3/5 Port Solenoid Valve

[Refer to the marks on the terminal board.] 240 VAC 240V VK300-82-2-07 6 VDC 6V VK300-82-4-51 12 VDC 12V VK300-82-4-06 24 VDC 24VD VK300-82-3-05 48 VDC 48VD VK300-82-3-53 For 12 VDC or below, there is no positive (+) or negative () directionality. 8 VK300-OMH0002-C VK300/3000 Series Specific Product Precautions 2 Be sure to read this before handling the products.

SI unit for DeviceNet ®

Dimensions for installation n: number of valve stations n L 1 2 3 4 5 6 7 8 L1 120.7 136.7 152.7 168.7 184.7 200.7 216.7 L2 80 96 112 128 144 160 176 n L 9 10 11 12 13 14 15 16 L1 232.7 248.7 264.7 280.7 296.7 312.7 328.7 344.7 L2 192 208 224 240 256 272 288 304 (mm) The above table shows dimensions as an example for the SY5000 series valve manifold.

EX510-GDN1.eng

Product type: 12 Product code: 100 Device information Duplicate MAC ID Check Message Group2 Only Unconnected Explicit Message Explicit Message, Poll/ I/O Message Put Claw 1 of the body under DIN rail and push it upward. Push down Claw 2 to the opposite rail until the claw clicks securely on to rail.

EX250-SPR_eng

BUS 3 3 X X B B 12 12 Technical documentation giving detailed diagnosis information and set-up steps information can be found on the SMC website (URL http://www.smcworld.com). PWR P P 1 1 A A Terminating resistors It is necessary to attach bus terminating resistance to the units located at the ends of transmission line.

EX510-GPR1.eng

To SI unit Branch connector at cable side Pin #1: Brown wire To Input unit Insert branch connector on the table side from the bottom (COM A, B, C, D of branch connector of GW unit side). 2 13 12 Wiring (continued) (2) Make sure to connect a "terminating resistor" to the units at the both ends of the system.

gaskets/pkg), VQ1000/VQ20/VQ30 VALVE*** $7.22 + Add to Quote Add To Cart Add to Cart SMC VVQ2000-80A-2 gasket set (1=12 gaskets/pkg), VQ1000/VQ20/VQ30 VALVE*** $6.41 +

gaskets/pkg), VQ1000/VQ20/VQ30 VALVE*** $7.22 + Add to Quote Add To Cart Add to Cart SMC VVQ2000-80A-2 gasket set (1=12 gaskets/pkg), VQ1000/VQ20/VQ30 VALVE*** $6.41 +

gaskets/pkg), VQ1000/VQ20/VQ30 VALVE*** $7.22 + Add to Quote Add To Cart Add to Cart SMC VVQ2000-80A-2 gasket set (1=12 gaskets/pkg), VQ1000/VQ20/VQ30 VALVE*** $6.41 +

gaskets/pkg), VQ1000/VQ20/VQ30 VALVE*** $7.22 + Add to Quote Add To Cart Add to Cart SMC VVQ2000-80A-2 gasket set (1=12 gaskets/pkg), VQ1000/VQ20/VQ30 VALVE*** $6.41 +

gaskets/pkg), VQ1000/VQ20/VQ30 VALVE*** $7.22 + Add to Quote Add To Cart Add to Cart SMC VVQ2000-80A-2 gasket set (1=12 gaskets/pkg), VQ1000/VQ20/VQ30 VALVE*** $6.41 +

gaskets/pkg), VQ1000/VQ20/VQ30 VALVE*** $7.22 + Add to Quote Add To Cart Add to Cart SMC VVQ2000-80A-2 gasket set (1=12 gaskets/pkg), VQ1000/VQ20/VQ30 VALVE*** $6.41 +