<br>For more information, refer to the D-MP□ series catalog or the video below.<br>A video about the D-MP□ series features and applications can be seen here.
<br>And the pivot bracket (clevis receiver) part numbers for the CM2E (integrated clevis) and CM2V (integrated clevis (90°)) are “CM-E020B” and “CM-E032B,” respectively.<br>Be sure to order the pins with the brackets for types other than the trunnion bracket.
<br>Contact SMC if the part number of the auto switch in use is not listed in the “Applicable Auto Switches” table for the old CDG1.<br>The D- series auto switch catalog can be found here.
<br>Note 1) Changing from the both ends tapped type (option “A”) to the head flange type (option “G”) or double clevis type (option “D”) is possible.<br>Note 2) For the long stroke type, the rod length is the same. Refer to the catalog for further details.
<br>① The workpiece is being repelled at the time of collision.<br>② The lever is not being fully engaged or it is taking too long to be fully engaged. The shock absorber used in the RSH20/32 series is a low-resistance type shock absorber, and it is available as a special order. Contact your local SMC sales office for further information about this custom shock absorber.
<br>Note 1) Be aware that the speed can increase temporarily due to bounding or knocking.<br>Note 2) Measurement within the accuracy range cannot be performed when the operating speed range is exceeded because normal pulses are not output.
<br>Note 1) In the pre-scale settings of the CEU5, select “CE1” for the connected model to connect a CE2 or ML2B series cylinder.<br>Note 2) The reset input wiring is different for the CEU1 and the CEU5. The CEP1, CE1, CE2, ML2B, and CEU5 operation manuals can be found here.
<br>However, the lateral load capacity is low due to this. Select an MGP series compact guide when the product is to be used as a stopper or when a large moment or lateral load will be acting on it. <br>The JMGP series catalog can be found here.
<br>However, for the current CG1 series cylinder, the needles are embedded to avoid mounting interference. <br>Regardless of whether the rubber bumper type or the air cushion type is selected, the overall length (mounting dimensions) are the same for both new and old CG1 series cylinders.
<br>The mounting dimensions of CG1Q and CG1Y-Z series products are the same. <br>Note) The CG1Q series was discontinued in September 2013 and was replaced with the current CG1Y-Z series.
<br>Refer to the CG3 series catalog for the load and speed conditions, which can be found here. <br>CG3 and CG1 series cylinders use the same metal fittings, but the rod end nut (for male threads) and the mounting brackets for bore size ø40 are dedicated for the CG3 series.
<br>The absorbed energy is higher than that of the metal stopper, and the positioning accuracy is equivalent. <br>The rubber stopper is a rubber cushion at the end of the adjusting bolt.
<br>In addition to the lock unit for maintenance (MWB□-UA), a lock unit with applicable rods (MWB□-UT-□) is also available. <br>The MWB series catalog can be found here.
<br>Note 1) Do not disassemble the shaft trunnion type because assembly accuracy is required. <br>Note 2) MB series seal kits come with a grease pack.