JXCx-OMT0005CN B-1 2 L A A-1 1 B B-2 6 B A-2 5 COM-A/COM B-3 3 COM-B/ A-3 4 3 Shield Vcc B-4 12 GND A-4 13 A B-5 7 A A-5 6 B B-6 9 B A-6 8 3 (14.2) 2 (2) 1 8 1 B1 A1 (14) 17.7 5 6 (3) 1 2 (18) A6 B6 15 16 (11) 30.7 L 15.2 [820m] 1 2 LE CP 2 A B-1 L 1 A A-1 6 B B-2 8 8m * 5 B A-2 3 COM-A/COM B-3 A 10m * 4 COM-B/ A-3 B 15m * 3 Shield C 20m * 12 Vcc B-4 13 GND A-4 * 7 A B-5 6 A
When a system hazard can be expected due to a drop in vacuum pressure caused by power loss or vacuum pump trouble, install a safety circuit and configure the system so that it can avoid the danger. 2. When a system hazard can be expected with a malfunction of the vacuum regulator, install a safety circuit and configure the system so that it can avoid the danger. 1.
, 2(B) port] 24 13.3 13.3 24 16.2 16.2 34 17 36.7 34 B 2 PE B 2 B 2 B 2 B 2 B 2 B 2 B 2 B 2 B 2 R 3 R 3 P 1 1 P A 4 X A 4 A 4 A 4 A 4 4 A 4 A 4 A 4 A 4 A 2-One-touch fitting [1(P), 3(R) port] Applicable tube O.D.: 8 2-One-touch fitting (X, PE port) Applicable tube O.D.: 6 2n2-One-touch fitting [4(A), 2(B) port] Applicable tube O.D.: 4, 6 U side D side (L4) Applicable connector: 26 pin MIL
Next, IB is entered to find IA the moment of inertia for the rotation of shaft (A) as a + b 2 2 A = ( ) b a 2 B = m 12 No. of teeth = b 11-10-3 4 Technical Data 3: Theoretical Output 5.
After blowing, make sure to hang the product on a hook, etc. Caution 1. Clean specification is not available with this product. When using in a clean room environment, confirm the required cleanliness before use. A minute amount of particles are generated due to wearing of the emitters while the product is operating. Wiring / Piping Warning 1.
Use 0.3 to 0.7 times the thrust (differs depending on the operating speed) as a guide for actual use. g: Gravitational acceleration Dynamic moment Mounting orientation Dynamic load FE Horizontal Ceiling Wall Vertical Z M 1.4 100 x a x mn x g 1 3 a a ME x FE x Z Dynamic moment ME Dynamic moment ME does not occur. 1 3 mn x g ME M3 ME x FE x Y mn x g ME FE FE Note) Regardless of the mounting
2%4$2$4$5 @4 #0 Section A-A' 20A Data A' $0 $1 #4 #5 #2 @1 $6 $3 Component Parts No. Description Cam follower cap Magnet Magnet Seal magnet Rail End spacer Square nut Square nut Spring pin Parallel pin No.
Position of rotation axis: Parallel to side b and passes a center of gravity. 1=m 12 a 2 1=m 4 r 2 oWith a load at the lever end rThin rectangle board (Parallelogram) Position of rotation axis: Perpendicular to the board and passes through center line. 2 1 2 2 a +K 1=m1 +m2 3 a Ex.)
Leakage voltage Particularly when using a resistor in parallel with a switching element and using a C-R element (surge voltage suppressor) to protect the switching element, take note that leakage current will flow through the resistor and C-R element, etc., creating a danger that the valve may not shut OFF.
(A value under a specified condition.) VX t Vaccuum pressure (Torr) The absolute pressure is expressed. 0 Torr=Absolute pressure 0.760 Torr=Atmospheric pressure (Gauge pressure 0 Kgf/cm2) (1 torr=1.33 X 102 Pa) VNl VQ Electrical Terms q Volt-ampere(VA) Volt-ampere is the product of voltage (V) and current (A). Power dissipation (W): For AC , W=V/A cos.
D-C7/C80 D-H7/H7W/H7F/H7BA 8.5 Hs Hs 8.5 16 16 B Auto switch 29 A 26 A Auto switch B D-C73C/C80C D-H7C Hs 8.5 Hs Auto switch 16 16 B Auto switch 38.2 A A 36.7 B D-G5/K59/G5W/K59W/G5BA/G59F/G5NT D-B5/B64/B59W Hs Hs 12 Auto switch 12 24.5 24.5 A B A B Auto switch 33 6.5 33 D-A3/G39/K39 D-A4 Hs Auto switch 36 Hs 36 Auto switch B A B A 49 49.5 G 1/2 (applicable cable 6.8 to 11.5) G 1/2 (applicable
(When port sizes for A, B ports are mixed, indicate C4 or C6 in cell .)
Caution indicates a hazard with a low level of risk which, if not avoided, could result in minor or moderate injury. Caution: Warning indicates a hazard with a medium level of risk which, if not avoided, could result in death or serious injury. Warning: Danger : Danger indicates a hazard with a high level of risk which, if not avoided, will result in death or serious injury.
Applicable for pressure detection with a wide range of fluids, by using a stainless steel diaphragm. 16-2-25 2 Pressure detection for a wide range of fluids.
Caution indicates a hazard with a low level of risk which, if not avoided, could result in minor or moderate injury. Caution: Warning indicates a hazard with a medium level of risk which, if not avoided, could result in death or serious injury. Warning: Danger : Danger indicates a hazard with a high level of risk which, if not avoided, will result in death or serious injury.
When a workpiece could be deformed during adsorption or transportion. (Example of a cardboard box) When the adsorption surface of a workpiece is slanted.
Caution indicates a hazard with a low level of risk which, if not avoided, could result in minor or moderate injury. Caution: Warning indicates a hazard with a medium level of risk which, if not avoided, could result in death or serious injury. Warning: Danger : Danger indicates a hazard with a high level of risk which, if not avoided, will result in death or serious injury.
14 16.5 1.0 Allowable moment coefficient 0.7 0.5 Note) For A, A, A and A, there is no difference in the corrected values due to the stroke.
Caution indicates a hazard with a low level of risk which, if not avoided, could result in minor or moderate injury. Caution: Warning indicates a hazard with a medium level of risk which, if not avoided, could result in death or serious injury. Warning: Danger : Danger indicates a hazard with a high level of risk which, if not avoided, will result in death or serious injury.