Micro Mist Separator with Prefilter AMH Model Model AMH250 AMH350 AMH450 AMH550 AMH650 AMH850 AMH150 Series AMH can separate and (1) remove aerosol state oil mist in 500 1000 2000 3500 6000 12000 200 Rated flow (l/min(ANR)) compressed air and remove Po

AMH850 is aluminum casting. w e Sight glass Tempered glass Replacement Parts AMH450 Part No. No.

PSE540/560

ZS-26-E-4 R04 4 plug-in reducer Connector for PSE300 1 pc.

Drain Separator for Vacuum Series AMJ 1

.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com Fluid: Air (pressurized) Measured pressure: Downstream release to atmosphere 0.01 0.005 Supply pressure (MPa) AMJ5000 0.001 AMJ4000 0.0005 AMJ3000 100 10 50 0.0001 500 1000 Air flow rate (l/min (ANR)) Construction q q OUT IN IN OUT t w r w e r e Component

CDQ2BP series

M o n m e t e r kg.m=kilogram-meter ft. lb = foot pound mm (H2O) = millimeter water column in (H2O) = inches water column mm (Hg) = fnillimeter mercury column in (Hg) = inches mercury column Basic Formulas Circle circumference = '[D = 2rr Circle atea = fit2 Force=PressurexArea Cylinder Volume (rod side) = (pislon area rod cross-section area) x stroke Cylinder Volume (head end) = piston area

Pin Clamp Cylinders

(Unclamping side) Bore size Nil Without lock L With lock 32 32 mm Auto switch type Nil Without auto switch (Built-in magnet) C D-P3DWASC E D-P3DWASE N D-P3DWA L D-P3DWAL Z D-P3DWAZ Guide pin diameter Mounting surface position (viewed from top) For guide pin diameter, refer to Table 1 below.

HRX-OM-W069

Table 3.8-2 RTU mode message frame a)Start b)Slave Address c)Function d)Data e) Checksum (CRC) f)End T1-T2-T3-T4 XX XX XX XX XX XX T1-T2-T3-T4 a) Start In Modbus RTU mode, message frames are separated by a silent interval (non-communication time).

HRX-OM-Z015

Table 3-6 RTU mode message frame a) Start b) Device Address c) Function d) Data e) Checksum (CRC) f) End T1-T2-T3-T4 XX XX XX XX XX XX T1-T2-T3-T4 a) Start In Modbus RTU mode, message frames are separated by a silent interval (non-communication time).

MRQB-OM0002

E1 2 I E[J]I[kg][rad/s] Imr m[kg] rm 5.1 19 I I I I kg kg kg kg m m m m 2 2 2 2 m: m: m: m: kg kg kg kg b 20 5-2. 5.1 5.1 32 0.023[J] 40 0.028[J] 2 t [rad]t[s] E E1 2 I t E 2 I t E[J][rad]I[kg] 2 t (1) t = & (2) C C t 2 1 tdt 2 + = = & & t=0 =0C=0 t 2 1 t 2 1 2 = = & t 2 = 21 5-3.

LC6D/LC6C

12 Red 12 E 2 phase stepper motor PD Yellow 11 F 8 5 phase stepper motor For a signal power supply of 24VDC, connect an external resistor R (1.3k 1/2W) in order to hold the current to 15mA or lower.

Compact Cylinder High Magnetic Field Design CDQ2BP Series

M o n m e t e r kg.m=kilogram-meter ft. lb = foot pound mm (H2O) = millimeter water column in (H2O) = inches water column mm (Hg) = fnillimeter mercury column in (Hg) = inches mercury column Basic Formulas Circle circumference = '[D = 2rr Circle atea = fit2 Force=PressurexArea Cylinder Volume (rod side) = (pislon area rod cross-section area) x stroke Cylinder Volume (head end) = piston area

Series LX Dedicated Stepper Motor Driver and Positioning Driver Series LC6D/LC6C

12 Red 12 E 2 phase stepper motor PD Yellow 11 F 8 5 phase stepper motor For a signal power supply of 24VDC, connect an external resistor R (1.3k 1/2W) in order to hold the current to 15mA or lower.

Low Differential Pressure Sensor

E Key lock function This function prevents incorrect operations such as accidentally changing the set value.

Series: NCDA1 (Standard w/ Magnet), Mounting: J (MT2, Head trunnion), Bore Size: 200 (2"), Stroke: 1000 (10"), Air Cushion / Rod Boot: Both Ends (Air Cushion), Thread: Nil (Small Male, Standard, Threaded), Adjustment Range: Not Applicable, Auto Switch: M9B--Solid State, Gen. Purpose, 2 Wire, Horizontal, Lead Wire or Prewired Connector: Z (5m)

Series: NCDA1 (Standard w/ Magnet), Mounting: B (MX0, Basic), Bore Size: 325 (3 1/4"), Stroke: 1000 (10"), Air Cushion / Rod Boot: Both Ends (Air Cushion), Thread: Nil (Small Male, Standard, Threaded), Adjustment Range: Not Applicable, Auto Switch: M9B--Solid State, Gen. Purpose, 2 Wire, Horizontal, Lead Wire or Prewired Connector: Z (5m)

Series: NCDA1 (Standard w/ Magnet), Mounting: B (MX0, Basic), Bore Size: 150 (1 1/2"), Stroke: 1000 (10"), Air Cushion / Rod Boot: Both Ends (Air Cushion), Thread: Nil (Small Male, Standard, Threaded), Adjustment Range: Not Applicable, Auto Switch: M9B--Solid State, Gen. Purpose, 2 Wire, Horizontal, Lead Wire or Prewired Connector: Z (5m)

Series: NCDA1 (Standard w/ Magnet), Mounting: U (MT1, Rod Trunnion), Bore Size: 325 (3 1/4"), Stroke: 1000 (10"), Air Cushion / Rod Boot: Both Ends (Air Cushion), Thread: Nil (Small Male, Standard, Threaded), Adjustment Range: Not Applicable, Auto Switch: M9B--Solid State, Gen. Purpose, 2 Wire, Horizontal, Lead Wire or Prewired Connector: Z (5m)

Series: NCDA1 (Standard w/ Magnet), Mounting: B (MX0, Basic), Bore Size: 400 (4"), Stroke: 1000 (10"), Air Cushion / Rod Boot: Both Ends (Air Cushion), Thread: Nil (Small Male, Standard, Threaded), Adjustment Range: Not Applicable, Auto Switch: M9B--Solid State, Gen. Purpose, 2 Wire, Horizontal, Lead Wire or Prewired Connector: Z (5m)

Bore Size: 32mm, Port Thread: Rc (25-100 Bore, M Thread 16-20 Bore), Piping: Standard, Stroke: 1000mm, Stroke Adjusting Unit: w/o Adjustment Unit, Auto Switch: M9B--Solid State, Gen. Purpose, 2 Wire, Horizontal, Lead Wire or Prewired Connector: Z (5m)

Bore Size: 40mm, Port Thread: M Thread (ø16) Rc Threads (ø25, ø40), Stroke: 1000mm, Stroke Adjustment Unit: Left, Right Side w/o Adjustment Unit, Auto Switch: M9B--Solid State, Gen. Purpose, 2 Wire, Horizontal, Lead Wire or Prewired Connector: Z (5m)

Bore Size: 80mm, Port Thread: Rc (25-100 Bore, M Thread 16-20 Bore), Piping: Standard, Stroke: 1000mm, Stroke Adjusting Unit: w/o Adjustment Unit, Auto Switch: M9B--Solid State, Gen. Purpose, 2 Wire, Horizontal, Lead Wire or Prewired Connector: Z (5m)