AC Servo Motor Driver (CC-Link Type) If you change by these by mistake, it may cause the amplifier to not work properly. -24- 5.3.4 Recommended Parameter Values by Actuator Model Please change the parameter values according to the customer application. Refer to LECSC Operation Manual,chapter 6 for details.
If you change by these by mistake, it may cause the amplifier to not work properly. -24- 5.3.4 Recommended Parameter Values by Actuator Model Please change the parameter values according to the customer application. Refer to LECSC2-T Operation Manual,chapter 6 for details.
state transition command is sent by setting Bit0-3 and Bit7 of Controlword (6040h).
Nonconformance caused by implementing no check-up (daily check-up, regular check-up) specified by SMC. 2. Nonconformance caused by the usage other than stipulated in the operating manual or outside the specification designated by SMC. 3. Nonconformance caused by remodeling which is not permitted by SMC. 4.
(made by SMC) Solenoid valve connection spec.
It must be installed by the customer.
Fix by bolts to prevent falling down. The bolts can be prepared separately as an accessory. Model No.
Remaining tape could cause imperfect cooling or failure by entering into the product.
High pressure switch 5) Operation restarts by turning on the white (operation) switch.
JOG moving Start testing Positioning data setting Speed setting of JOG / fixed distance Fixed distance moving Teaching box Setting and operation by the simple screen without scrolling. Select function by the iconized menu at the first page.
If the rubber viscosity increases, replace the pad. (18) The product with pressure switch with energy saving function reduces air consumption by stopping air supply by creating vacuum between the check valve and pad in the ejector while adsorbing the workpiece.
If the rubber viscosity increases, replace the pad. (18) The product with pressure switch with energy saving function reduces air consumption by stopping air supply by creating vacuum between the check valve and pad in the ejector while adsorbing the workpiece.
Products approved by CSA or UL standards are accepted in most states and governments beyond question.
The optimum operating position can be determined by the color of the light.
For standard installation, turn 2 to 3 turns using tool after fastening by hand. Take care not to damage the product by over torque.
Do not carry a cylinder by the auto switch lead wires. Never carry a cylinder by its lead wires. This may not only cause broken lead wires, but it may cause internal elements of the switch to be damaged by the stress. 3. Mount switches using the proper tightening torque.
with the stroke by the 1 mm interval by using an exclusive body with the specified stroke Intermediate strokes by the 1 mm interval are available by using spacers with standard stroke cylinders.
(prepared by the user) I/O cable PLC Actuator cable (prepared by the user) Card Motor 24 VDC power supply for the input / output signals Power supply cable (prepared by the user) (prepared by the user) Counter plug (attached to the controller) 24 VDC power supply for the controller Power supply plug (prepared by the (attached to the controller) user) Controller 15 - I/O cable pin assignment
ME 4O3LR-5 Assembty Kit. oo sTnugfloN Each of the manltold blocks and ths manlfold End Plates aro aftlxd to its adjacenl block by a unlqu pair ot "V" Clamp Platss h6ld together by two bolts and nuts.