<br>Note) For LECP1/P2 series controllers, there is only 4-point input (IN0 to IN3). <br>Step Data Number Table
<br>The return to origin direction will change after the power is turned OFF and then ON again after changing the parameters. <br>Note) When the return to origin direction is changed, reset the position adjusted by the user.
<br>If the actuator is the type with a lock, connect the lock cable to the controller, apply 24 VDC to the “Unlock/BK-RLS” terminal, lock, and then perform the operation. If the lock is released with the actuator in the vertical direction, the moving part may fall under its own weight. <br>Perform unlocking only after ensuring sufficient safety.
<br>The connection cable for use between the PC and the controller is a dedicated cable. Order an LEC-W2A-C communication cable and an LEC-W2-U USB cable. <br>Note) Connecting using a commercially available cable (LAN cable, etc.) may result in the malfunction of the product.
<br>Whereas for RESET, it decelerates and then stops. This deceleration is the “max. acceleration” value (basic parameter). <br>The servo remains ON after stopping in this case.
<br>Use an AREA signal to do this. The AREA signal turns ON when the current position is within the AREA1 to AREA2 range. <br>AREA1 and AREA2 can be set for each step.
<br>By using this “RESET” signal, the following operations can be performed: <br>① Step no. 0 operation instruction → ② “RESET” signal ON (stop during operation) → ③ Step no. 2 operation instruction
<br>Since this Z-phase signal is a signal that is output once per motor, the motor moves about 1 to 2 rotations during this operation. <br>For example, the LEFS25AA is an actuator with a lead of 12 mm, so it moves about 12 to 24 mm during this operation.
<br>For details, refer to the operation manual on the SMC website. <br>If the situation persists, reinstallation may be required.
<br>If the DRIVE and IN_* signals are input at the same time, since the controller reads the step number from the IN_∗ signal before it has been fully input, the desired movement cannot be performed. <br>Be sure to set DRIVE to ON at least 15 ms after inputting the IN_∗ signal.
<br>The ZB series catalog can be found here. <br>These vacuum ejectors were designed with a focus on increasing suction speed and reducing product size and weight for mounting on moving parts to allow for the high-speed suction and transfer of handlers, chip mounters, etc.