KP/KPQ/KPG Polyurethane tubing: Series TU, Nylon tubing: Series T, and Soft nylon tubing: Series TS can also be used. However, the degree of clean performance will be reduced.
Since E has no polarity, it can also be used as a negative common.
ao . , , , , t o o 3 . , , . , 05 stePping a ''.a: ' , . a , : a : l r : : i : l ::: I iob' ' ', ' t99;:9i1':i1:t t: llli,2.gtepping O8: 12mm lead , , . , , 1 ( } . u 5 asbinriea,i : r iri llliqq'i'' o5 stepoinq 30 08; zmm lead o2 stepping 80 08; 5mm lead 10.03 30 08; 2mm lead s5 stepping 80 08; 5mm lead a I a a a 100 O8; 6mm lead o2 stepping I M <-iD;;,;; uo200 08; 12mm lead 10.05 100 08
Note 3) The non plug-in type cannot be mounted afterwards.
Be sure to observe the set pressure range and maximum operating pressure.
Be sure to observe the set pressure range and maximum operating pressure.
Polyurethane tubing: Series TU, Nylon tubing: Series T, and Soft nylon tubing: Series TS can also be used. However, the degree of clean performance will be reduced.
Polyurethane tubing: Series TU, Nylon tubing: Series T, and Soft nylon tubing: Series TS can also be used. However, the degree of clean performance will be reduced.
For the part numbers of the SI units to be mounted, refer to pages 108 and 109. (IP40 specifications may be required according to the I/O unit to be selected.)
Vacuum (V) and exhaust (E) port should not be sealed simultaneously.
Also, the surge pressure must be under the maximum operating pressure.
The trunnion bracket must be ordered separately.
It will be locked set in a (Passage: PA) state. Turn the manual override counterclockwise by 180 to set the mark to B and press it in the direction indicated by the arrow. It will be reset in a (Passage: PB) state. (It is reset when shipped.)
Note 2) Pressure switch cannot be mounted later on non plug-in type. 4 V or less 0.2 to 0.9 MPa Non plug-in type Caution Air filter with auto-drain or manual drain must be mounted with the air filter at the bottom. 3-5-24 25 5 Port Pilot Operated Solenoid Valve Rubber Seal, Plug-in/Non Plug-in Series VFR2000 How to Order VV5FR2 10 1 08 AP 01 Air release valve coil rating Series VFR2000 Manifold
/G59F/G5NTL Double clevis CA1-D04 CA1-D05 CA1-D06 CA1-D08 CA1-D10 BA-04 BA-05 BA-06 BA-08 BA-10 When ordering foot brackets, 2pcs. should be ordered for each cylinder.
The OUT direction can be mounted up to 90 to the left or right.
Reduction Silencer Exhaust), Nominal Nozzle Size: 10 (ø1.0), Supply Valve and Release Valve: R (Self-holding Release Valve Linked / N.C.), Rated Voltage: 5 (24 VDC), Vacuum Sensor: C (Digital Pressure Switch for Vacuum / 0 to -101 kPa / PNP 2 Outputs), Connector: L [L-type Plug Connector - w/ Lead Wire with Connector - w/ Lead Wire with Connector for Pressure Switch/sensor], Vacuum, V Port: 08
. / N.C.), Rated Voltage: 5 (24 VDC), Vacuum Sensor: H (Digital Pressure Switch for Vacuum / -100 to 100 kPa / PNP 2 Outputs), Connector: L [L-type Plug Connector - w/ Lead Wire with Connector - w/ Lead Wire with Connector for Pressure Switch/sensor], Vacuum, V Port: 08 [ø8 One-touch Fitting (Metric)], Bracket: B [With One Bracket for Mounting a Single Unit (Mounting Screw is Attached)],