OUT1, OUT2: OrangeIP65Operating: 23 to 122F, Stored: 14 to 140F (No freezing or condensation)Operating/Stored: 35 to 85% RH (No condensation)1000 VAC for 1 minute between live parts and case50 M or more between live parts and case (at 500 VDC Mega)10 to 150 Hz at whichever is smaller of 1.5 mm amplitude or 20 m/s2 acceleration, in X, Y, Z directions, for 2 hours each (De-energized)100 m/
Abnormal values can be seen at a glance on the 2-color display.?
OUT1, OUT2: OrangeIP65Operating: 23 to 122F, Stored: 14 to 140F (No freezing or condensation)Operating/Stored: 35 to 85% RH (No condensation)1000 VAC for 1 minute between live parts and case50 M or more between live parts and case (at 500 VDC Mega)10 to 150 Hz at whichever is smaller of 1.5 mm amplitude or 20 m/s2 acceleration, in X, Y, Z directions, for 2 hours each (De-energized)100 m/
EX600-SPN_eng The tightening torque at the valve side depends on the valve type. Refer to the operation manual of the corresponding valve manifold.
ST(M) Red flashing (2)Mount and tighten the end plate at one end of the unit. (M4) Tightening torque: 0.7 to 0.8 Nm. Fix the end plate at the valve side while referring to the operation manual of the corresponding valve manifold. Caution Internal communication error between SI unit and I/O unit is detected. Red/green flashing SI unit has failed.
Connected to the fluid inlet at IN and to the fluid outlet at OUT. Piping port The body of the product. Body : Example for 500 L/min type : The set values of OUT2 and the accumulated value of OUT2 cannot be displayed. : To display other indications than "Set values" normally, perform settings referring to the function selection mode.
Connected to the fluid inlet at IN and to the fluid outlet at OUT. The body of the product. Body These safety instructions are intended to prevent hazardous situations and/or equipment damage. These instructions indicate the level of potential hazard with the labels of "Caution", "Warning" or "Danger".
Connected to the fluid inlet at IN and to the fluid outlet at OUT. The body of the product. Body Switch ON Display (2) Change the set value using the or button, and press the SET button to set the value. Then, the setting moves to hysteresis setting.
In accumulated output mode, the switch will start at the set accumulated flow rate. Set each P1/P2 (set value), referring to the Setting method on above.
IN side and to the fluid outlet at OUT side. ( ) These safety instructions are intended to prevent hazardous situations and/or equipment damage.
Settings can be copied to up to 10 slave sensors at once?
Settings can be copied to up to 10 slave sensors at once?
Settings can be copied to up to 10 slave sensors at once?