Rotary Actuator Applicable shaft types: S, W, Y Equal dimensions are indicated by the same marker.
The port 2(A) pressure is fed back to the control circuit by the pressure sensor.
When multiple vacuum pads are operated by one vacuum generator, and some of them are not holding the work piece, the reduction of vacuum pressure is restricted and the work piece can remain held by the rest of pads.
The stop position will be automatically redressed by re-try function.
Example) 3 mm width spacer is installed in the standard cylinder 10CQSXB25-50D to make 10CQSXB25-47D. 50, 63 Action Rod end thread Manufacturing of Intermediate stroke Intermediate strokes by the 1 mm interval are available by using spacers with standard stroke cylinders. But, as for 40 with damper, please consult SMC separately.
Balance the load by adjusting the air pressure in the front and rear sides of the cylinder with the load connected to the cylinder and the lock released. Lurching of the cylinder when unlocked can be prevented by carefully adjusting this air balance. Note) Can be used if all of the generated moment is absorbed by an effective guide. 2.
Piston rod lurching, due to cracking pressure at start up, has been eliminated by means of a floating seal mechanism.
Measurement instruments that SMC manufactures or sells have not been qualified by type approval tests relevant to the metrology (measurement) laws of each country.
Do not carry a cylinder by the auto switch lead wires. Never carry a cylinder by its lead wires. This may not only cause broken lead wires, but it may cause internal elements of the switch to be damaged by the stress. 3. Mount switches using the proper tightening torque. When a switch is tightened beyond the range of fastening torque, the mounting screws or switch may be damaged.
Check that they do not exceed the upper limit, by referring to Work loadAcceleration/Deceleration Graph (Guide) (Pages 124 to 126). For the ball screw type, there is an upper limit of the speed depending on the stroke. Check that if it does not exceed the upper limit, by referring to the specifications (Page 133).
Multiple barriers are not to be used in parallel unless specifically permitted by the barrier certification.
Tighten it by giving consideration to prevent the tightening torque from being applied to the non-rotating guide.
Do not carry a cylinder by the auto switch lead wires. Never carry a cylinder by its lead wires. This may not only cause broken lead wires, but it may cause internal elements of the switch to be damaged by the stress. 3. Mount switches using the proper tightening torque. When a switch is tightened beyond the range of fastening torque, the mounting screws or switch may be damaged.
(Power supply cut) GW unit reset by turning power OFF and back ON.
The initial exhaust rate is set to zero by turning the adjustment nut clockwise until it just stops. (Do not use a tool.) The initial exhaust rate is adjusted by turning the nut anti-clockwise.
Care shoul d be t aken w hen a cabl e m ade by ot her com pany i s used.
When input unit is not used Power supply for DeviceNet can be operated by 11 to 25 VDC.
Displacement at the section indicated by the arrow when a load is applied to this section with the slide table fully extended. Displacement at the section indicated by the arrow when a load is applied to this section with the slide table fully extended.
Window comparator mode: ZSE The hysteresis is two digits, so separate P1 from P2 by five digits or more and set them. ISE The hysteresis is three digits, so separate P1 from P2 by seven digits or more and set them. * (One digit is the minimum pressure display unit) 2 Analogue output has no overcurrent detection unit Courtesy of Steven Engineering, Inc. !
When handling a switch, hold it by the switch body. The tensile strength of the power source cord is 49 N. If pulling with more strength, switch may be damaged. When handling a switch, hold it by the switch body. 3. Operation by the button Refer to the instruction manual for operating by the button for the digital pressure switch. 4. Do not touch the LCD readout.