KJ

Nylon, Soft nylon, Polyurethane 3.2, 4, 6 Specifications Fluid Air/Water Note) 1.0 MPa 100 kPa 3.0 MPa 5 to 60C, Water: 0 to 40C (No freezing) JIS B 0203 (Taper thread for piping) JIS B 0209, Class 2 (Metric coarse thread) Mounting section Maximum operating pressure Operating vacuum pressure Proof pressure Ambient and fluid temperature Thread Nut section With thread seal JIS B 0211 Class

ChemicalThermo-con

Terminal block 5 External sensor: Terminal B of resistance temperature detector 6 External sensor: Terminal B of resistance temperature detector 7 FG D A Pin No. Signal contents A short pin is installed between No. 1 and No. 2 pins to short-circuit it (Remote ON) when shipped.

0.5

US Edition B Safety Instructions Be sure to read the Handling Precautions for SMC Products (M-E03-3) and Operation Manual before use.

SMC Electronic Switch Series Variations

E: Emitter C: Collector B: Base B: Base Load Electrical appliance connected to the output, e.g. relay, solenoid, etc. E: Emitter C: Collector Fig.2 NPN type Fig.3 PNP type Operating humidity range Humidity range for proper operation of equipment. Load current Current flow through the electrical appliance once the output is energized.

HRX-OM-M005

W&F Contact B OUT6 N/A Output signal: OFF (open) for normal operation 4 OUT1 to OUT6 Contact A, B Output signal A: Contact A, B: Contact B Same as above Used to display the 5 [Enter] key MESSAGE screen to accept the setting. Used to display the MESSAGE screen to initialize the settings of RUN, REMOTE, and 6 [Initial] key OUT1 to OUT6. 7 [Cancel] key Used to cancel the setting.

Gun Type Ionizer

The specified ambient temperature range is 0 to 40C.

Dedicated Controller Series LC1 Uniaxial Type

5 to 40C 5 to 40C 5 to 40C Electric energy 180VA 640VA 300VA 300VA 640VA 100VA 300VA 640VA 640VA 300VA 180VA 300VA Control system AC software servo/PTP control Position detection system Incremental encoder Home position return function Maximum positioning point setting With magnet switch as adjacent switch, and encoder Z phase signal as home position signal.

HAA

8 B 3 8 B 1 2 Thermometer for outlet air temp.

PVC Quick Drain Valve

or less Isobutyl alcohol Note 1), 2) Temperature 40C or less Isopropyl alcohol Temperature 40C or less Note 1), 2) Hydrochloric acid Concentration 30% or less Note 2) Hydrogen peroxide Concentration 5% or less, Temperature 50C or less Nitric acid (except fuming nitric acid) Concentration 10% or less, Temperature 40C or less Note 2) Deionized water Sodium hydroxide (Caustic soda) Concentration

Moisture Control Tube

After unpacking the product, store it at a temperature of 40C or less and relative humidity of 75% or less. 7. Do not use the tube in atmosphere or compressed air containing solvent. 5. Clean the tube and the actuator by air blowing to eliminate moisture before connecting them to the circuit with condensation. 8. Do not wipe or clean the product with alcohol.

CATALOG

L E T U B E OD 6 A P P L I C A B L E T U B E OD 6 Courtesy of Steven Engineering, Inc. !

Table of Contents

B 1.8 1.6 Groove position of auto switch A 10.4 12.8 Model MHK2-12 MHK2-16 A B Dimensions A and B of other models are same as standard switch grooves.

7

flow ratio to be b = 0.3.

2 Phase Stepper Motor/Without Motor Brake Series LXS

(B contact) S N.C. (B contact) Lead screw lead N.C. (B contact) A B 6mm 12mm N.C. (B contact) N.O. (A contact) N.O. (A contact) Stroke N.O. (A contact) 50 75 100 125 150 50mm 75mm 100mm 125mm 150mm Use a driver with CE marking. N.O.

10

A 24 VDC 5 Size 2 B E A B 4 N.C. Resin B C D E F G H J K L M N P Q R S T U V W 100 VAC Grommet 7 N.O. 110 VAC With surge voltage suppressor 200 VAC Size 3 C F A B 5 N.C.

Direct Operated Pilot Operated 2-Port Solenoid Valve Refer to pages 7, 9, 11, 25, 35, and 39 for details.

60534-1:2005 IEC 60534-2-3:1997 JIS B 2005-1:2012 JIS B 2005-2-3:2004 Equipment: JIS B 8471, 8472, 8473 Cv Process fluid control equipment 2.

ISO Cylinder

A B Hs Hs Hs Hs Hs Hs Hs Hs Hs Hs D-M9lV D-M9lWV D-M9lAV D-A9lV D-M9lV D-M9lWV D-M9lAV D-A9lV 17 B A A B D-H7l D-H7lW D-H7BA D-H7NF D-C7l D-C80 D-F7l D-F7lW D-J79 D-J79W D-F7BA D-F79F D-A7lH D-A80H 17 A B A B D-F7lV D-F7lWV D-F7BAV D-A7l D-A80 D-A79W D-H7C 17 A B A B D-C73C D-C80C D-J79C D-A73C D-A80C 17 Auto Switch Made to Order B A B A 102 C85/C75 Series Auto Switch Proper Mounting

2/3 Port Valve

Class B H B Class H DIN connector or DC not available.

2 Phase Stepper Motor/Without Motor Brake Series LXP

(B contact) N.C. (B contact) Lead screw lead N.C. (B contact) N.C. (B contact) 6mm 12mm A B N.O. (A contact) N.O. (A contact) Stroke N.O. (A contact) 50mm 75mm 100mm 125mm 150mm 170mm 200mm 50 75 100 125 150 170 200 N.O. (A contact) Use a driver with CE marking.

Table of Contents

ON-flow 0.04 40 B p ipe pe 3/4 B p pi 3B 30 1 0.03 2B, pipe 20 0.02 , 5B , 4B pe 1/4 1 B pi 10 Max.