EX600-SEN_eng Green NS LED is flashing Red PWR(V) LED is On Red MS LED is flashing Red NS LED is flashing Red ST(M) LED is On Red PWR LED is On Green MS LED is On Green NS LED is On Green LEDs are On Red MS LED is On Red NS LED is On LED display The power supply for control and input is Off, or IP address is not set.
: IP IP [IP ]( 19 ) 12 PLC PLC SI TM NS: EtherNet/IP PLC PLC SI TM NS: EtherNet/IP NS: IP IP [IP ](19 ) -38No.EX-OMS0026CN No.
NS + Stroke Width across flats B1 Width across flats KA 4-ND through Bottom hole diameter NE 8-NC counterbore S + Stroke ZZ + Stroke Rod End Female Thread BS + Stroke S + Stroke ZZ + Stroke Dimensions except mentioned above are the same as male thread type.
Then, Red/green NS LED is flashing alternately For use in Pollution Degree 2 Environment (UL508) Pollution degree Solenoid valve with lamp and circuit of protection of surge voltage of 24 VDC 1.5 W (SMC) Connected load Green MS LED is On and red NS LED is On Red/green ST(M) LED is flashing alternately Control and input Green MS and NS LEDs are both On A unit other than the SI unit has been
resistance Impact resistance Noise resistance IP65 0 to 50C Resistance 1000 VAC for 1 min. between external terminal and case 50M or more (500 VDC Mega) between external terminal and case 10 to 500 Hz with a 1.5 mm amplitude or 98 m/s2 acceleration in each X, Y, Z direction for 2 hrs, whichever is smaller. 490 m/s2 in X, Y, Z directions 3 times each 1000 Vp-p, Pulse width 1 s, Rise time 1 ns
(de-energized) 490 m/s2 in X, Y, Z directions 3 times each 1000 Vp-p, Pulse width 1 s, Rise time 1 ns Status LEDs Response time Hysteresis Power supply voltage Enclosure Operating temperature range Withstand voltage Insulation resistance Vibration resistance Impact resistance Noise resistance Note 1) For digital flow switch with unit switching function.
LED check Refer to fault EtherNet/IPTM device NS No. 1 LED is ON or flashes () Yes No EtherNet/IPTM device NS Refer to fault Scan is not No. 2 LED is OFF available Refer to fault IP address is not No. 3 held Green ON, Green flashes, Red ON, or Red flashes. -13No.EX-OMV1026-B Troubleshooting list Fault No.1 Problem Possible cause Investigation method Countermeasures Set the IP address switch
mode: Variable (can be set from 0), Window comparator mode Note 6): 3-digit fixed 12 to 24 VDC 10% Enclosure Operating temperature range Withstand voltage Insulation resistance Noise resistance IP65 Environment 0 to 50C 1000 VAC for 1 minute between terminals and housing 50 M or more (500 VDC measured via megohmmeter) between terminals and housing 1000 Vp-p, Pulse width 1 s, Rise time 1 ns
2 i MS, NS Communication status LED Displays the status of the EtherNet/IPTM communication t o ENC z Encoder connector (16 pins) Axis 1: Connect the actuator cable. !0 MOT z Motor power connector (6 pins) !8 @1 !1 ENC x Encoder connector (16 pins) Axis 2: Connect the actuator cable. !2 MOT x Motor power connector (6 pins) !9 @0 !3 !4 y !
Select a valve from R, U, NS or NZ when the SI Unit common is negative common.
No wireless slaves connected (Non-restorable error in wireless communication) 4 W-NS Red/Green Wireless communication connection is under construction. (Pairing) Orange LED is ON.
Wireless communication connection status PB72, 02231, Espoo, Finland W-NS Restorable error is detected. (LED flashes when more than one diagnostic information item is detected.)
of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com CX D-X 20Data (mm) Stroke (mm) 5 10 15 20 25 30 TS Z S NS LS BS 52.5 53 41.5 14 14 10 57.5 58 46.5 14 19 14 62.5 63 51.5 24 25 18 67.5 68 56.5 24 30 24 75.5 76 64.5 34 40 32 79.5 80 68.5 34 45 35 8-3-7 8 Series MXU Dimensions
(de-energized) 980 m/s2 in X, Y, Z directions 3 times each (de-energized) 500 Vp-p, Pulse width 1 s, Rise time 1 ns Connection Material Weight Power supply / Output connection: 8P connector, Sensor connection: 4P connector (e-con) Housing: PBT, Display: PET, Backside rubber: CR 60 g (Except for any accessories that are shipped together.
St a nd a rd Spe cifi ca t io ns Fluid V9L9P",3!t9 lMin. operating pressurellq ?sr_(9q9q!
MS status Description NS status Installation Green On Green On On-line state, The device has connections in the established state.
MM NC 7.5Depth4.5 9Depth5.5 10.5Depth6.5 13.5Depth8.5 17Depth10.5 NS 43 45 44 54 53 Model MUB25 MUB32 MUB40 MUB50 MUB63 KA 10 12 14 18 18 N 14 15.5 16 21.5 21.5 ND M5 X 0.8 M6 X 1 M8 X 1.25 M10 X 1.5 NE 4.3 5.1 6.9 8.7 10.5 S 55 58 60 74 75 ZZ 69 72 75 92 96 M10 X 1.25 M8 X 1.25Depth13 M12 X 1.25 M14 X 1.5 M18 X 1.5 M18 X 1.5 M8 X 1.25Depth13 M10 X 1.5Depth15 M10 X 1.5Depth15 M12 X 1.75 2.4
34 45 35 8-3-7 8 Series MXU Dimensions: MXU16 (mm) Stroke (mm) 5 10 15 20 25 30 TS Z S NS LS BS 65.5 66 52 24 24 20 65.5 66 52 24 24 20 75.5 76 62 34 35 30 75.5 76 62 34 35 30 85.5 86 72 40 45 40 90.5 91 77 40 50 45 8-3-8 9 Compact Slide Series MXU Construction MXU6 (6) MXU10 (10) MX MTS MY CY MG CX MXU16 (16) D-X With auto switch 20Data Component Parts No. q Note Hard anodized No. !
St a nd a rd Spe cifi ca t io ns Fluid V9L9P",3!t9 lMin. operating pressurellq ?sr_(9q9q!
Stations: 4 Stations, Port Size: N7 (1/4" One-touch Fitting), Kit Name: F (D-sub Connector 25 Pin), Electrical Entry: S (Side), Cable Length: 0 (w/o Cable 25 Pin), Option 1: None, Option 2: None, Option 3: N (Name Plate), Option 4: None, Option 5: S (Built-in Silencer, Direct Exhaust)