<br>However, for the current CG1 series cylinder, the needles are embedded to avoid mounting interference. <br>Regardless of whether the rubber bumper type or the air cushion type is selected, the overall length (mounting dimensions) are the same for both new and old CG1 series cylinders.
<br>The mounting dimensions of CG1Q and CG1Y-Z series products are the same. <br>Note) The CG1Q series was discontinued in September 2013 and was replaced with the current CG1Y-Z series.
<br>Refer to the CG3 series catalog for the load and speed conditions, which can be found here. <br>CG3 and CG1 series cylinders use the same metal fittings, but the rod end nut (for male threads) and the mounting brackets for bore size ø40 are dedicated for the CG3 series.
<br>The absorbed energy is higher than that of the metal stopper, and the positioning accuracy is equivalent. <br>The rubber stopper is a rubber cushion at the end of the adjusting bolt.
<br>In addition to the lock unit for maintenance (MWB□-UA), a lock unit with applicable rods (MWB□-UT-□) is also available. <br>The MWB series catalog can be found here.
<br>Note 1) Do not disassemble the shaft trunnion type because assembly accuracy is required. <br>Note 2) MB series seal kits come with a grease pack.
<br>A signal is output when there has been no numerical change for a certain period of time, so this signal can be used to indicate when the cylinder has stopped. <br>This function is useful for detecting the push position or resetting the value at the cylinder origin position.
<br>For the manufacturable stroke range, refer to the “Cylinder Stroke” section in the catalog. <br>The CE1 and CEP1 series catalogs can be found here.
<br><br>
<br>However, bottom side (head side) flanges are not available. <br>For bottom mounting, use the special order part number suffix “-XC82” that eliminates the need for relief machining of the guide during mounting. (Note that the selectable bearing types and strokes are limited for this type.)
<br>Note) For the ball bushing type, a high-precision type can be selected for both standard MGP and MGPW series cylinders. <br>The MGPW series catalog can be found here.
<br>When ordering an individual auto switch, prefix a “D-” to the part number.<br>As the CDQ2B32-30DMZ-M9BW is a cylinder with 2 auto switches, be sure to order 2 D-M9BW auto switches if 2 are needed.
<br>The solid state auto switches listed in the “Applicable Auto Switch” tables are all available as standard. Reed auto switches are available as a special order.<br>The special order options are shown at the end of the solid state auto switch catalog, which can be found here.
<br>If the power is turned ON without a load connected to the auto switch, an overcurrent will flow and the auto switch will be instantly damaged.
<br>・Production of the new D-M9□(W)(V) auto switch commenced in June 2016, and production of the new D-M9□(W)(A) auto switch commenced in September 2016.
<br>For example, the outer diameter of the cylinder tube differs between the JCM series and the CM2 series.<br>For use with a non-JCM series cylinder, proper auto switch operation verification is required.