Outlet changing procedure After the terminal block has been separated from its housing, reassemble the housing in the desired direction (in four 90 increments) to change the cord outlet. Precautions Kindly insert the connector straight in without tilting it, and pull it out straight.
System configuration Make sure to install a mist separator (Series AM) on the inlet side of the booster valve. Also install a cleaning device such as an air filter or a mist separator on the outlet side as necessary. Because the booster valve contains a sliding mechanism and the inner wall of the tank for the booster valve is untreated, dust flows out to the secondary side.
Lubricant Table ttanuf9ctuf's I LuDrrcrm BP THB 32 Castrol Perfecto T32 ESSO/Exxon TERESSO 32 Mobil DTE Lig ht Shell Turbo T32 @ 4 Port Solenoid Yalve NVZlOOO Symbol NVZ1120 A B NVZ1120-OG-t\,ts-F NVZlI2GOG.M5 Model o.2 (90) Spec ifications Air, Inert gases Operating Pressure range 20-1ooPst(1.5Ambient and fluid Max.120'F(50"C) Response time 15 ms or less (atTOPSI) Max.operating 900 cpm Manual
(Or None in the Case of No Switch), Auto Switch Unit: AM [With Vertical Auto Switch Unit for D-M9 (Built-in Magnet)]
(Or None in the Case of No Switch), Auto Switch Unit: AM [With Vertical Auto Switch Unit for D-M9 (Built-in Magnet)]
Shaft Type: W (Double Shaft with Single Flat), Size: 40, Rotating Angle: 90°, Auto Switch: No Switch, Lead Wire: 0.5m (Or None in the Case of No Switch), Number: 2 pcs. (Or None in the Case of No Switch), Unit: B (With Angle Adjustment Unit)
Shaft Type: Double Shaft with Single Flat, Size: 40, Rotating Angle: 90°, Auto Switch: No Switch, Lead Wire: 0.5m (Or None in the Case of No Switch), Number: 2 pcs. (Or None in the Case of No Switch), Unit: With Angle Adjustment Unit
Therefore, in addition to the air filter (SMCs AF series), make sure to use a mist separator (SMCs AM, AFM series). Concerning the quality of the operating air, refer to SMCs air preparation equipment selection guide (pages 2 and 3). 2.
Insulating sheet, etc Electrode materials, etc Solar battery cell, etc Standardization of multi-port* * Except 40 300 Thickness of workpiece (m) Grease-free Can be disassembled and cleaned the inside. 0 730 Non-contact Gripper XT661 Series Related Products Mist Separator Regulator 2 Port Valve General Air AR ARM10 VXZ VQ20 AM (Filtration degree: 0.3 m) Membrane Air Dryer Super Mist Separator
Precision Regulator IR1000-A/2000-A/3000-A Series RoHS ARJ Reduced by Up to approx. 90% AR425 to 935 Sensitivity: 0.2% (Full span) * Air consumption Repeatability: 0.5% (Full span) ARX [L/min (ANR)] AMR IR Current model Series ARM 1 or less 4.4 IR1000-A/IR2000-A 1 or less 11.5 IR3000-A Space saving ARP New structure without fixed throttle does not require a mist separator. * Compared with
(IDF )(AF/AFF )(AFM/AM , -9- 4 4 4 4-2. 2. 2. 2. 4-2-1. D D 4-2-2.
The factory default pump output setting is 90%. 4.2 Starting and Stopping HRR Series 4-2 HRX-OM-X084 Chapter 4 Starting the Product ECO F RUN MPa ALM PSI Lighting up WRN LPM GPM RUN MPa ALM M WRN RMT LPM RUN H EXT SEC RMT H AT SEC MENU RUN/ STOP MENU RUN/ STOP ENT RESET Press and hold for approximately 1second.
Setting unit: 0.5 hours to For example: Run timer setting performed at 5:30 PM on the previous day to start the product operation 14 hours later (at 7:30 AM on the next morning) PV SV HRS Series 5.7 Run Timer and Stop Timer Function 5-17 HRX-OM-W032 Chapter 5 Display and Setting of Various Functions Setting/checking: Stop timer 4. Press the [SEL] key once.
After it comes into contact with the gasket of the coaxial cable pedestal, continue to tighten it by 90 degrees clockwise. * To ensure IP67 water and dust Included M2.6 x 8 screw: x 2 Recommended torque 0.9+/-10%Nm resistance Bracket Coaxial cable 2 x M4 Recommended torque 1.3+/-10%Nm -59No.EX-OMZ0016-C Attach the male connector of the coaxial cable to the antenna connector of the wireless
+ info;
document.getElementById('3dStats').appendChild(stImg);
var _cart_secure_url = "https://www.smcpneumatics.com"
var refEncoded = encodeURIComponent(document.referrer);(new Image()).src = 'https://www.smcpneumatics.com/3dvisit.asp?
Then, reinstall the terminal cover in the desired direction (in 90 increments).
Then, reinstall the terminal cover in the desired direction (in 90 increments).
Then, reinstall the terminal cover in the desired direction (in 90 increments). 14-9-20 5 5 Port Electro-pneumatic Proportional Valve Series VER2000/4000 Construction VER2000 F.R.L.
Therefore, in addition to the air filter (SMCs AF series), make sure to use a mist separator (SMCs AM, AFM series). Concerning the quality of the operating air, refer to SMCs Compressed Air Cleaning Systems on page 14-14-2. 2.
Series CRB2-Z, single or double vane, rotary actuator is availbable in 10, 15, 20, 30 and 40 bore. The single vane style use specially designed seals and stoppers which enable this compact type actuator to rotate up to 270 degrees. Double vane type i ROTARY ACTUATOR. Actuator, Rotary Vane Type. 547.00000 lb. 519.